- ページ 7

バスタブ Ariel Whirlpool BT seriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ariel Whirlpool BT series 10 ページ。

User manual whirlpool D-series with Bluetooth

Once a device is connected to the system it will auto-detect when Bluetooth function activated on the control panel. If there is more

than one device paired to the system, the system will choose one of them automatically. If the system connects to wrong device,

deactivate the Bluetooth function by pressing the Music button then press and hold the Music button for 3 seconds and the Bluetooth

symbol will start flash and the system is in search mode.

Turn off and on the Bluetooth function or open Bluetooth function on the device for connection and pairing with the "Whirlpool".

Sound volume can adjust using the parameter setting buttons set into 9 different volume levels.

Air pump:

Press the air pump button to activate the pump.

Whether the water is above or below the water sensor, if you press the air pump button, the air pump will start and blow warm air

through the bottom jets. The air pump will automatically shut down after 20 minutes. If the water level changes from above to below the

sensor, the air pump will stop automatically. The icon of the air pump will start to flash. In order to activate the air pump again, press the

air pump button. If the water pump and air pump both work at the same time but with a different start time, both pumps will automatically

turn off after 20 minutes.

To stop the air pump, press the air pump button.

When the water no longer detected on the water level sensor, the air pump will run automatically after 20 minutes for a preset

time of 1 minute to dry the air jets.

And it will do it in these three different scenarios:

1. Water is no longer detected by the water level sensor with system still turned on

2. Water is no longer detected by the water level sensor and then the system is turned off

3. System is turned off and after that the water no longer detected by the water level sensor.

Page 7 / 9