- ページ 7

エアコン Toshiba 35S3AVP-NDのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Toshiba 35S3AVP-ND 40 ページ。
Toshiba 35S3AVP-ND にも：オーナーズマニュアル (24 ページ)

ページを印刷する

1. Installation Manual

How to Install Indoor Unit

1. Remove the air inlet grille. Open the air inlet grille and remove the strap.

2. Remove the front panel (Remove the 4 screws).

Front panel

Hook

Air inlet grille

Layout of connection piping

100

542

108

Treatment of piping connection

1) Check the ﬂ are nut connections for the gas leak with a gas leak detector

or soap water.

2) To prevent gap in slit, fasten top and bottom with tape.

3) Slit is covered with tape.

4) Fasten with supplied Insulate sheet to prevent gap on the top of slit.

Gas leak check

Drainage

1. Run the drain hose sloped downwards.

NOTE

• The hole should be made at a slight downward slant on the outdoor side.

Do not rise the

drain hose.

Do not put the

drain hose end

into water.

Connection piping

Tape

Slit

Insulation sheet

Do not form the

drain hose into

a wavy shape.

Do not put the

drain hose end in

the drainage ditch.

2. Put water in the drain pan and make sure that the water is drained out of

doors.

3. When connecting extension drain hose, insulate the connecting part of

extension drain hose with shield pipe.

Shield pipe

Inside the room

Drain hose

CAUTION

Arrange the drain pipe for proper drainage from the unit.

Improper drainage can result in dew-dropping.

Wiring connection

Wiring of the connection cable is necessary to remove the front panel.

1. Remove the terminal cover and cord clamp.

2. Insert the connecting cable (according to the local rule) into the pipe hole

on the wall.

3. Take out the connecting cable through the cable slot on the rear panel so

that it protrudes about 50 cm from the front.

4. Insert the connecting cable fully into the terminal block and secure it

tightly with screws.

5. Tightening torque : 1.2 N·m (0.12 kgf·m)

6. Secure the connecting cable with the cord clamp.

7. Fix the terminal cover, install the front panel and grille inlet.

CAUTION

• Be sure to refer to the wiring system diagram labeled inside the front

panel.

• Check local electrical cords and also any speciﬁ c wiring instructions or

limitations.

Hook

Screw

430 mm

Stripping length of the connecting cable

NOTE

• Use stranded wire only.

• Wire type : H07RN-F or 60245 IEC66 (1.0 mm

Extension drain hose

Terminal

block

Screw

Earth line

Cord clamp

Earth screw

110 mm

Earth line

20 mm

10 mm

50 mm

or more)