- ページ 8

室内暖炉 Dimplex BF362SDのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dimplex BF362SD 12 ページ。
Dimplex BF362SD にも：サービスマニュアル (13 ページ), オーナーズマニュアル (14 ページ)

heater control switch is activated. The heater may emit a slight,

harmless odor when first used. This odor is a normal condition

caused by initial heating of internal heater parts and will not occur

again.

Resetting The Temperature Cutout Switch

The heater on this fireplace is protected with a safety device to prevent

overheating. Should the heater overheat, an automatic cutout will turn

the heater off and it will not come back on without being reset. It can

be reset by switching the Main Power Switch (FIGURE 3) to Off and

waiting 5 minutes before switching it to On. The remote control will

need to be re-initialized. (See page 3)

CAUTION: If you need to continuously reset the heater, disconnect

the power at the main service panel and call your local dealer

Maintenance

WARNING: Disconnect all power coming to fireplace at main service

panel before attempting any maintenance or cleaning to reduce risk

of fire, electric shock or damage to persons.

Light bulbs need to be replaced when you notice a dark section of the

flame of when the clarity. There are four bulbs under the log set which

generate the flames and embers.

NOTE: Allow at least five minutes for light bulbs to cool off before

touching bulbs to avoid accidental burning of skin.

Helpful Hints

It is a good idea to replace all light bulbs at one time if they are close to

the end of their rated life. Group replacement will reduce the number

of times you need to open the unit to replace light bulbs. Long life

bulbs are recommended to reduce the frequency of bulb changes.

Bulb Requirements: Quantity of 4 clear chandelier or candelabra

bulbs with an E-12 (small) socket base, 60 watt rating. Example: