- ページ 9
室内暖炉 Dimplex BF392SDのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dimplex BF392SD 12 ページ。 Built in 2 sided fireplace
Dimplex BF392SD にも： インストレーション・マニュアル (4 ページ), サービスマニュアル (13 ページ), トラブルシューティングマニュアル (4 ページ), オーナーズマニュアル (14 ページ)
ページを印刷する
GE 60BC or Philips 60CTC.
Do not exceed 60 Watts per bulb.
Tool Requirements: Slot Screw Driver
To access the light bulb area:
FIGURE 4
Screws
FIGURE 5
Back
Ledge
Rear
Tab
Side Section
ledge (FIGURE 5) and the logs are resting against mirror.
8. Replace log bracket using two screws previously removed.
Mirror Cleaning
The mirror is cleaned in the factory during the assembly operation.
During shipment, installation, handling, etc., the mirror surface may
collect dust particles; these can be removed by buffing lightly with a
clean dry cloth.
1. Open steel curtain (remove
2. Remove two screws on log
3. Pull rear edge of ember bed up
Log
4. Examine the bulbs to determine
Ember
bed
5. Unscrew bulbs counter
Front
6. Insert new bulbs.
Edge
7. Replace the log by inserting
6
glass doors if applicable). The
bulbs can be accessed from
either side of the fireplace.
bracket and remove log plate
(FIGURE 4).
and forward by grasping ember
bed by the sides (handle the
logset only by the emberbed
and not the logs) and pulling
solidly until the rear tab pops
out from under the back ledge,
then lift out. (FIGURE 5)
which bulbs require
replacement.
clockwise.
front edge and under back