Power
Lamp
Temperature
light
light
light
Flashing
Off
Off
green
Green
Off
Off
Flashing
Off
Off
orange
Red
Off
Flashing red
Red
Flashing
Off
red
—
Flashing
Off
orange
Red
Off
Red
Flashing
Off
Flashing
red
orange
Orange Off
Off
Description
The projector is warming up.
Wait for the image to appear.
The projector is operating
normally.
The projector is cooling
down. Wait for the light to
stop flashing and remain
orange before unplugging it.
There is a problem with the
fan or a sensor. Turn off the
projector and unplug it.
Contact Epson for help.
The lamp is burned out,
broken, or not installed
correctly, or the lamp cover is
open. Close the cover or
replace or reseat the lamp, if
necessary, as described on
page 12.
Replace the lamp with a new
one as soon as possible. See
page 12 for instructions. If
you continue to use the lamp,
there is a risk it may break.
The projector has overheated
and turned itself off. Let it
cool for about five minutes,
then turn it back on. Make
sure there is plenty of space
around and under the
projector for ventilation. Also
clean the air filter and air
exhaust vents. If it continues
to overheat, you may need to
replace the air filter.
The projector is too hot.
Make sure the room is not
above 95 °F and there is
plenty of space around and
under the projector for
ventilation. Clean the air filter
and air vents, if necessary.
The projector is in standby or
sleep mode. You can unplug
it or press the P Power
button to turn it on.
Epson PowerLite 61p/81p Projector
Cleaning the Lens
Clean the lens whenever you notice dirt or dust on the surface.
Use a canister of compressed air to remove dust.
To remove dirt or smears on the lens, use lens-cleaning
paper. If necessary, moisten a soft cloth with lens cleaner and
gently wipe the lens .
Caution:
Do not use glass cleaner to clean the lens.
Cleaning the Projector Case
Before you clean the case, first turn off the projector and unplug
the power cord.
To remove dirt or dust, wipe the case with a soft, dry, lint-
free cloth.
To remove stubborn dirt or stains, wipe the case with a soft
cloth moistened with a mild detergent.
Caution:
Do not use wax, alcohol, benzene, paint thinner, or other
chemical detergents. These can damage the case.
Cleaning and Replacing the Air Filter
Clean the air filter and air intake and exhaust vents on the
bottom and rear of the projector after every 100 hours of use.
If not cleaned periodically, they can become clogged with dust,
preventing proper ventilation. This can cause overheating and
damage the projector. When the filter is clogged, the projector
displays the message
To clean the air filter and air vents, follow these steps:
1. Turn off the projector, allow it to cool down, and unplug the
power cord.
2. Clean the air vent on the back of the projector.
Use a small vacuum cleaner designed for computers and
other office equipment. If you don't have one, use a very soft
brush (such as an artist's brush).
6/04
Epson PowerLite 61p/81p Projector
The projector is overheated
.
11
-
ページを印刷する