- ページ 6

モニター Philips 104S CM23 GSIIIのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Philips 104S CM23 GSIII 9 ページ。 14” auto scan colour monitor chassis

Mechanical Instructions

104S CM23 GSIII

Go to cover page

0. General

To be able to perform measurements and repairs on the "circuit

boards", these unit should placed in the service position first.

1. Remove the rear cover

- Open two lids with "-" type screwdriver. Refer to fig2 and fig3.

- Remove 4 screws with "+" type screwdriver.

lids

2. Video panel

- Remove the metal shielding on rear side of Video panel by

desolder lags of metal shielding.

3. Main panel

- Disconnect the degaussing coil from Main panel.

- Remove the video panel from CRT.

- Remove the "screw" of I/F cable from Main panel.

- Disconnect the CRT ground "1701" from Video panel.

- Disconnect the Hi-Pot cap from CRT.

- Disconnect the yoke wire connector "1601" from Main panel.

- Slide the main panel out of bottom tray.

- Place Main panel in service position as shown in Fig.1.

- Mount Video panel again on CRT.

lid

- To connect Hi-Pot cap again.

- To connect "1701" again.

- To connect the yoke wire "1601" again.

Fig.2

screws

Fig. 1

Fig.3