- ページ 5

テレビ Toshiba 20A23のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Toshiba 20A23 16 ページ。 Toshiba portabler tv 20a23
Toshiba 20A23 にも：オーナーズマニュアル (33 ページ), サービスマニュアル (33 ページ)

ページを印刷する

REMOTE CONTROL

1. POWER Button - Press to turn on the TV. Press again

to turn off the TV.

2. Direct Channel

Selection

Buttons (0-9) - Allows direct

access to any channel.

3. OH RTN Button - Repeatedly

press CH RTN to toggle

back and forth between the last two channels you tuned.

4. SLEEP Button - To set the TV to turn off after a preset

amount of time, press the SLEEP button on the remote

control. The clock will count down 10 minutes each time

the button is pressed in the order of 120, 110, 100, -..... 20,

10, 0. After the sleep time is programmed,

the display will

disappear then reappear momentarily every ten minutes to

remind you the sleep timer function is operating. To

confirm the sleep time setting, press the SLEEP button

once and the remaining time will be momentarily

displayed.

To cancel sleep time, press the SLEEP button repeatedly

until the display turns to 0.

5. VOL (VOLUME) +/-

Buttons - Press the + button to

increase, or the - button to decrease the volume level.

6. MENU Button - Press to display the on-screen menu

function.

7. SET +/-

Buttons - Press to select the desired setting

during on-screen operations.

RESET Button - Press to reset the on-screen picture

adjustments to their factory preset positions.

9. TV/VIDEO Button - Switches between the TV and external

device inputs.

10.

RECALL Button - When you press this button, the

channel number will appear in the upper right corner of the

screen. Press the button again to remove it from the

screen.

11. MUTE Button

- TO turn off the sound, press this button

once. The TV will be silenced and the word "MUTE" will

appear on the screen. The muting feature can be released

by pressing the MUTE button again or one of the VOL + or

- buttons.

12. OH (CHANNEL)

+/-

Buttons - Press the + button to

change to a higher numbered channel set into memory.

Press the - button to change to a lower numbered channel

set into memory.

13.

ENTER Button - Press to enter or select information

for

On-screen operations.

14. 1/2 Button - Switches between Channel 1 and Channel 2

in the Closed Caption mode.

15. CAP/TEXT

Button - Press to switch between normal TV

and the two Closed Caption modes (captions or text), when

available.

Before using the remote control, batteries must first be installed.

HOW TO INSTALL

BATTERIES

Use two "AAA" size penlight batteries (supplied) for the

1. Open the battery compartment cover.

remote control. The batteries may last approximately one

year depending on how much the remote control is used.

For best performance, it is recommended that batteries

should be replaced on a yearly basis, or when the remote

operation becomes erratic.

2. Install two "AAA" (penlight size) batteries.

3. Replace

the battery

compartment

cover.

BATTERY PRECAUTIONS

These precautions should be followed when using batteries

in this device:

1. Use only the size and type of batteries specified.

2. Be sure to follow the correct polarity when installing the

batteries as indicated in the battery compartment.

Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g.

Alkaline and Carbon-zinc) or old batteries with fresh

ones.

4. If the remote control will not be used for a long period of

time, remove the batteries to prevent damage or injury

from possible battery leakage,

5. Do not try to recharge batteries not intended to be recharged;

they can overheat and rupture. (Follow battery

manufacturer's directions.)