Previewing Image Sources
You can use the Preview function to help you select the image
source.
1. Press
on the remote control.
Preview
Preview
You see the currently selected source displayed in the main
window, as shown below. All sources (including the
currently selected source) are displayed in smaller preview
windows on the right side and at the bottom. If no
equipment is connected to a port, or if there is no incoming
signal, the preview window for that source appears blank.
Note: Movies are displayed as still images on the preview
screen.
Currently selected source
2. Press one of the
Source
switch to the desired source. Or press
preview screen without switching sources.
Note: A red highlight surrounds the preview window for the
currently selected source. You can use the
the remote control to highlight a different source, and then press
to display it.
Enter
Preview windows
buttons on the remote control to
to exit the
ESC
pointer button on
EPSON PowerLite 9300i Projector
Troubleshooting Display Problems
Follow these guidelines if you're having trouble displaying an
image.
You Can't Project an Image
If you see a blank screen or a blue screen with the
message, try the following:
Make sure the cables are connected correctly.
Make sure the power light is green and not flashing and the
lens cover is off.
If you've connected more than one computer and/or video
source, you may need to press one of the
the projector's control panel or the remote control to select
the correct source. (Allow a few seconds for the projector to
sync up after pressing the button.)
If you're using a Windows/PC notebook, press the function
key on your keyboard that lets you display on an external
monitor. It may be labeled
as
. You may have to hold down the
pressing it. Allow a few seconds for the projector to sync up
after changing the setting.
The Projector and Notebook Don't Display the
Same Image
If you're projecting from a notebook, and you don't see the
same image on the projection screen and on your computer
screen, follow these guidelines.
If you're using a Windows/PC notebook:
On most systems, there's a function key that lets you toggle
between the LCD screen and the projector, or display on
both at the same time. It may be labeled
an icon such as
key while pressing it. Allow a few seconds for the projector
to sync up after changing the setting.
If the function key doesn't permit you to display
simultaneously on both screens, you should check your
monitor settings to make sure both the LCD screen and the
external monitor port are enabled.
1. From the Control Panel, open the
2. In the Display Properties dialog box, click the
then click
Advanced
3. The method for adjusting the settings varies by brand; you
may need to click a
external Monitor port is set as your primary display and/or
enabled.
See your computer's documentation or online help for
details.
10/03
Source
or have an icon such
CRT/LCD
Fn
CRT/LCD
. You may have to hold down the
Display
.
tab, then make sure the
Monitor
EPSON PowerLite 9300i Projector
No Signal
buttons on
key while
or with
Fn
utility.
tab,
Settings
7
-
ページを印刷する