- ページ 38

マザーボード MSI 612BFのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。MSI 612BF 48 ページ。 3d-agp vga / 3d-audio m/b for socket 370
MSI 612BF にも：マニュアル (45 ページ)

PRESS F1 TO DISABLE NMI, F2 TO REBOOT

When BIOS detects a Non-maskable Interrupt condition during boot, this will allow you to

disable the NMI and continue to boot, or you can reboot the system with the NMI enabled.

RAM PARITY ERROR - CHECKING FOR SEGMENT ...

Indicates a parity error in Random Access Memory.

Should Be Empty But EISA Board Found

PLEASE RUN EISA CONFIGURATION UTILITY

A valid board ID was found in a slot that was configured as having no board ID.

NOTE; When this error appears, the system will boot in ISA mode, which allows you to run the

EISA Configuration Utility.

Should Have EISA Board But Not Found

PLEASE RUN EISA CONFIGURATION UTILITY

The board installed is not responding to the ID request, or no board ID has been found in the

indicated slot.

NOTE:

When this error appears, the system will boot in ISA mode, which allows you to run

the EISA Configuration Utility.

Slot Not Empty

Indicates that a slot designated as empty by the EISA Configuration Utility actually contains a

board.

NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the

EISA Configuration Utility.

SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT ...

Indicates the present boot attempt has been aborted and the system must be rebooted. Press

and hold down the CTRL and ALT keys and press DEL.

Wrong Board In Slot

PLEASE RUN EISA CONFIGURATION UTILITY

The board ID does not match the ID stored in the EISA non-volatile memory.

NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the

EISA Configuration Utility.

FLOPPY DISK(S) fail (80)  Unable to reset floppy subsystem.

FLOPPY DISK(S) fail (40)  Floppy Type dismatch.

Hard Disk(s) fail (80)

Hard Disk(s) fail (40)

Hard Disk(s) fail (20)

Hard Disk(s) fail (10)

Hard Disk(s) fail (08)

 HDD reset failed

 HDD controller diagnostics failed.

 HDD initialization error.

 Unable to recalibrate fixed disk.

 Sector Verify failed.