- ページ 5

ソフトウェア Epson Stylus Photo RX600のPDF スタート・ヒア・マニュアルをオンラインで閲覧またはダウンロードできます。Epson Stylus Photo RX600 10 ページ。 Product support bulletin(s)
Epson Stylus Photo RX600 にも：ヒント (2 ページ), 製品情報シート (4 ページ), 製品情報 (19 ページ), パンフレット (2 ページ), セットアップマニュアル (2 ページ), クイック・スタート・マニュアル (28 ページ), ユーザーマニュアル (12 ページ), 更新 (1 ページ), 製品サポート速報 (6 ページ), 製品サポート速報 (1 ページ), 仕様 (2 ページ), コピーと印刷の方法 (20 ページ), 取扱説明書 (4 ページ)

Open the cartridge cover by pulling it toward you.

Remove the ink cartridges from their packages.

Caution: You must install all the cartridges

and leave them installed for all types of printing.

To avoid damaging the RX600, never move the

print head by hand.

Lower each cartridge into the holder marked

with the corresponding color.

Press down on each cartridge until it clicks

into place. Then close the ink cartridge cover

until it clicks into place.

Caution: Don't force the cartridge cover

closed. If it doesn't close easily, open it and

make sure all the cartridges are firmly seated.

Lower the scanner unit.

The RX600 begins charging the ink

delivery system.

Charging takes about 2 minutes. Initial

charge appears on the RX600 screen.

Caution: Don't turn the RX600 off while

you see the Initial charge message or

you'll waste ink.

Load Paper

Insert the paper support into the two slots on the back of the RX600.

Open the output tray.

Flip the feeder guard forward.

Place a stack of paper in the top

of the RX600, between the edge

guides and beneath their tabs.

Then slide the left edge guide

against the paper, but not

too tightly.

Flip the feeder guard back over the

stack of paper.

Note: If you don't flip the feeder

guard back, your paper may jam.

Turn over