- ページ 42

オール・イン・ワン・プリンター Toshiba E-Studio 5506ACのPDF 用紙準備マニュアルをオンラインで閲覧またはダウンロードできます。Toshiba E-Studio 5506AC 46 ページ。

Stapling Using the Finisher

You can staple with the Finisher or the Saddle Stitch Finisher copied paper manually without any copying operation.

This is useful when you have forgotten to set the staple sort mode before starting copying, or when you want to staple

originals. For models supporting the manual staple mode and the maximum sheets that can be stapled for each

model, refer to the Specifications Guide.

Use the buttons on the stapling control section of the Finisher for manual stapling.

Stapling position

button / lamps

Press the stapling button on the stapling control section.

The manual staple mode starts.

Press the stapling position switching button to switch the staple position (front or rear).

Place paper on the lower receiving tray of the Finisher.

Fan and jog the paper well. Place it with its face down.

When you staple them at their corner on the front side, place the sheets of paper aligned to the front side. When

you staple them on the rear side, place the sheets of paper aligned to the rear side.

The stapling lamp lights when the paper is fully loaded and properly placed. If it does not light, replace the paper.

Let go of the paper, and then press the stapling button.

Stapling starts. When the stapling position switching lamps start blinking, it means the stapling has finished.

Then remove the stapled paper.

Be sure that your hands are away from the paper while stapling is in progress.

Finishing the manual staple mode

Remove the stapled paper from the lower receiving tray, and then press the stapling button. The manual staple

mode ends. If no operation is performed for approx. 15 seconds, the manual staple mode will be automatically

finished.

42 Stapling Using the Finisher

Stapling

button / lamp