- ページ 13

ノートパソコン MSI MS-1057のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。MSI MS-1057 27 ページ。 12,1" wxga notebook

2-3 Use a flathead screwdriver to disengage (Open) the socket actuator, as shown in figure 2-3a below.

The socket actuator should open after only a half turn, and then you should be able to remove the

processor with your fingers.

2-4 Place new processor into the socket. Align processor's pin A1 (shown in figure 2-4) with the arrow on

the micro-FCPGA socket. Pin A1 of the processor is identified with an embroidered corner and pin A1 of

the socket is identified with a small arrow. If the processor does not drop completely into the socket, turn

the actuator until the processor drops in completely.

!!!You do not have to press down the processor. If the processor does not drop completely into

the socket, turn the actuator until the processor drops in completely.

2-5 While gently holding the processor down with your finger, secure the processor in the socket by

closing the socket actuator with a screwdriver (See Figure 2-5)