- ページ 6

オール・イン・ワン・プリンター Toshiba e-STUDIO7518AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Toshiba e-STUDIO7518A 20 ページ。 Sys board diagnosis tool
Toshiba e-STUDIO7518A にも：マネジメント・マニュアル (32 ページ), 取扱説明書 (32 ページ)

ページを印刷する

1. Table of Contents
2. Introduction
3. Usb Memory Requirements
4. Procedure to Use the Diagnostic Tool
5. Usb Advanced Preparation

4. Remove the short pin attached to CN106 of the SYS Board and then insert the short

pin on one side of CN106 as shown in the figure below.

5. Insert the USB memory containing the Diagnostic tool into the usb port locate on the

left-side of Control Panel or the upper right side of the machine (the USB memory

insertion slot location differs depending on the model).

6. Insert the power cable into the MFP.

7. Turn on the Main power switch ON (all covers must be closed).

8. The following screen with a progress bar will be displayed and the automatic check

process is started.