- ページ 19
ステレオシステム Philips AZ 2905のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Philips AZ 2905 21 ページ。 Cd radio cassette recorder
Philips AZ 2905 にも： オーナーズマニュアル (21 ページ), ユーザーマニュアル (2 ページ), 仕様 (2 ページ), 仕様 (2 ページ), オーナーズマニュアル (21 ページ), オーナーズマニュアル (21 ページ)
ページを印刷する
TROUBLESHOOTING
WARNING
Under no circumstances should you try to repair the set yourself, as this will invalidate
the guarantee.
If a fault occurs, first check the points listed below before takeing the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Problem
Possible cause
Solution
No sound / no power -VOLUME is not adjusted
•Adjust the VOLUME
- Headphones are connected
• Disconnect headphones
- Speakers are not or wrongly connected • Check speaker connection
- Mains cable is not securely connected
• Connect the mains cable properly
-Batteries are exhausted
•Replace batteries
-Batteries are incorrectly inserted
• Insert the batteries correctly
-Changing over from mains to battery
• Pull out the power plug from the
supply without removing the plug
unit's AC MAINS inlet
No reaction to
- Electrostatic discharge
• Disconnect the set from power supply
operation of any keys
reconnect it after a few seconds
Poor radio reception -Weak radio antenna signal
•Aim the antenna for optimum
reception:
- FM/SW: incline and rotate telescopic
antenna
- AM/MW/LW: rotate the entire set
- Interference caused by the vicinity of
• Keep the radio away from electrical
electrical equipment like TVs, video
recorders, computers, engines, etc.
equipment
no d ISC
or
-The CD is badly scratched or dirty
• Replace or clean the CD, see
Error
indication
maintenance
-No CD is inserted
•Inserta CD
-The CD is inserted upside down
• Insert a CD with label upwards
-The laser lens is steamed up
•Wait until the lens has cleared of
The CD skips tracks
-The CD is damaged or dirty
-shuffle or program is active
•Replace or clean the CD
• Switch off shuffle or program play
Poor cassette sound
quality
- Dust and dirt on the heads, capstan
or pressure roller
- Use of not suited cassette types
(METALorCHROME)
-Clean the heads, capstan and pressure
roller, see maintenance
• Only use NORMAL cassettes for
recording
Recording does not
work
- Cassette tab[s) may be broken out
the missing tab space
•Apply a piece of adhesive tape over
Remote control does
not function properly
- Batteries are incorrectly inserted
-Batteries are exhausted
-Distance to the set is too large
• Insert the batteries correctly
•Replace batteries
•Reduce the distance
19