- ページ 9
DVDプレーヤー Toshiba SD-170EKBのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Toshiba SD-170EKB 24 ページ。
ページを印刷する
labelled as 75 ohm or RF In), you will need a RF
modulator in order to view the DVD playback on
the TV.
Use the composite video cable (yellow) to connect
A
the DVD player' s VIDEO OUT (CVBS) jack to the
video input jack on the RF modulator (cable sup-
plied).
To hear sound of this DVD player through your TV,
use the audio cables(white/red) to connect AUDIO
OUT (L/R) jacks of the DVD player to the cor-
responding AUDIO IN jacks on the RF modulator
(cable supplied).
Use the RF coaxial cable (not supplied) to connect
B
ANTENNA OUT or TO TV jack on the RF modulator
to the ANTENNA IN jack on the television.
Connect the Antenna or Cable TV service signal to
C
the ANTENNA IN or RF IN jack on the RF modulator.
(It may have been connected to your TV previously.
Disconnect it from the TV.)
Connecting to a Stereo System
MAINS
Stereo system has Dolby Pro Logic or Right/Left
Audio In Jacks
Select one of the video connections (SCART IN,
A
CVBS VIDEO IN or COMPONENT VIDEO IN)
depending on the options available on your TV.
Use the audio cables (white/red) to connect AUDIO
B
OUT (L/R) jacks of the DVD Player to the corres-
ponding AUDIO IN jacks on the stereo system .
Tip:
-Analogue audio out will not have sound if DTS
playback is selected.
Helpful hint: before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.
Connecting to a Digital AV Receiver
MAINS
Receiver has a PCM, Dolby Digital or MPEG
decoder
Select one of the video connections (SCART IN,
A
CVBS VIDEO IN or COMPONENT VIDEO IN)
depending on the options available on your TV.
Connect the COAXIAL jack of the DVD player to the
B
corresponding Digital Audio In jack on your Receiver
(cable not supplied).
Set the DVD Player' s Digital Output to PCM-Only or
C
ALL depending on the capabilities of your Receiver
(see page 18 {Digital Output}).
Tip:
-If the audio format of the Digital Output does not
match the capabilities of your receiver, the receiver
will produce a strong, distorted sound or no sound at
all.
Connecting the power cord
MAINS
After everything is connected properly, plug in the AC
power cord to the power outlet.
Never make or change any connections with the
power switched on.
"no disc" will appear on the display window when you
press the ON/STANDBY button with no disc loaded.
Connections
To AC outlet