- ページ 11

プロジェクター Toshiba TDP-MT400のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Toshiba TDP-MT400 23 ページ。 Dlp projector

ページを印刷する

Connection

Before connection

• Read the owner's manual of the device you are connecting to the projector.

• Some types of computer cannot be used or connected to this projector.

Check for an RGB output terminal, supported signal

• Turn off the power of both devices before connecting.

• The figure below is a sample connection. This does not mean that all of these devices

can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)

Computer (for control)

Video recorder,

DVD player, etc.

To S-Video

To RS-232C

output

p.43

terminal

S-Video cable

Control cable

(supplied)

RGB component video cable

(not supplied)

To Y/C

output

Green (Y)/Blue (C

)/Red (C

DVD video recorder, etc.

Notes

• If you want to feed the digital RGB signal, separately available DVI cable is needed.

• If you are using the digital RGB signal for input to this unit, some computer models or a

certain type of DVI cable may cause on rare occasions noise on the screen. If such is a

case, decrease your computer's refresh rate or the resolution. It is also recommended to

use a DVI cable in 2 m or less in length.

p.39

, etc.

VCR, etc

To video

output

Video cable (supplied)

DVI cable

(not supplied)

RGB cable

(not supplied)

)

To DVI output

To RGB output

Computer

English

Français

Español

Turning the power on and off

Connecting the power cord

Insert the power cord connector into the

AC IN socket of the projector.

Insert the power cord plug into a wall or

other power outlet.

Removing the lens cover

Be sure to remove the lens cover when the power is

turned on. If it is left on, it could become deformed due

to heat.

Turning the power on

Turn on the main power switch

The ON indicator will change to

orange, indicating standby mode.

• After the main power switch is turned

on, the inner cooling fan starts

cooling.

Press the ON/STANDBY

button.

The power turns on, and the following

3 green indicators light: ON, LAMP,

and FAN. After a moment, the start-up

screen appears.

CAUTION

• Do not look into the lens while the lamp is on. The strong light from the lamp may cause

damage to your eyes or sight.

• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause

burns, deform/break the object.

Deutsch

Italiano

Português Svenska

Power cord connector

(Supplied)

(Orange)

Remote

Control panel

Control

Start-up screen