- ページ 13

プロジェクター Toshiba TLP-S10のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Toshiba TLP-S10 33 ページ。 1,200 ansi-lumens 2.1 kg eco mode
Toshiba TLP-S10 にも：オーナーズマニュアル (22 ページ), オーナーズマニュアル (22 ページ), 仕様 (2 ページ)

ページを印刷する

(4) Select [Front] button first, and select R, G or B

button.

(When you adjust the R level, then select R-

VCOM)

The current data is displayed in DATA column.

Push (+1) or (-1) button; adjust the data to reduce

the flicker to its minimum point.

By pushing the (+4) or (-4), the data is adjusted

in greater steps.

After the adjustment, click the [Save] to save

the data.

Adjust G and B panels too.

At this time, generates the signal corresponding

to adjusting color.

(Note)

Take notes of the flicker appearing data by

fluctuation of the data.

Input the data by reference to midpoint between

the highest and lowest data.

(5) Select [Ceiling] button.

Adjust in the same procedures as step 4, and

click the [Save] to save the data.

5. Gamma Adjustment

adjustment when main PC board is

replaced)

The VT (input voltage-optical transmissivity)

characteristics of the LCD panel are uneven. So

gamma correction is required. The adjustment is used

to write already corrected gamma data after the main

PC board replacement.

5-1. Copy of gamma data

When the main PC board is in operation, gamma data

can be read from the projector. Copy the data of current

main PC board to new one.

(1) Select [GAMMA] and click [Receive].

During data transfer, the progress bar shows the

status.

(2) After the transfer is completed, message box

appears to save data. Name the file and click

[Save] to save transferred data.

(Perform the