- ページ 5

室内装飾品 Croydex 5012044112446のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Croydex 5012044112446 8 ページ。 Foil wrapped flat pack cabinets

ページを印刷する

SECTION 3 - MOUNTING THE CABINET

TOOLS REQUIRED

10.

Place the cabinet in the desired position

on the wall and mark the position of the

top mounting hole.

(See Fig. 10)

fig. 10

11. For solid walls

drill an 8mm hole in the

marked position. Then insert the wall plug

to the surface of the wall. If fitting to a tiled

surface, the wall plug should be inserted

the surface

of the tile to avoid cracking.

IMPORTANT!

If the wall plugs are not inserted flush with the

wall surface, the O-ring will not contact the

wall correctly.This will prevent the bracket from

functioning properly.

(See Fig. 11)

For cavity walls

drill an 11mm diameter hole

and assemble the top bracket and metal

washer onto the toggle bolt as shown, ensure

the 11mm diameter toggle bolt insert is pushed

into the hole in the plaster board wall for

maximum strength.

(See Fig. 11)

8/11

Top mounting hole

flush

below

fig. 11

Toggle Bolt Insert

12.

Fasten the top bracket to the wall

ensuring

the O-ring is correctly seated

at the back of the bracket.

OVERTIGHTEN!

This image shows solid

wall installation.

IMPORTANT:

The top bracket has a

smaller diameter outer flange to the

bottom bracket.

(See Fig. 12)

fig. 12

13.

Hang the cabinet onto the top wall

bracket and secure in place by screwing the

locking cap onto the top bracket.

(See Fig. 13)

fig. 13

8mm OR 11mm drill

Top or Bottom Bracket

DO NOT

CAB 150 R01