- ページ 2

ヒーター Dimplex CVP1のPDF 設置および操作説明書をオンラインで閲覧またはダウンロードできます。Dimplex CVP1 4 ページ。 Dual warmth heater
Dimplex CVP1 にも：設置および操作説明書 (4 ページ)

ページを印刷する

Follow the sequence outlined below when installing the heater.

Select the position for the heater ensuring there is

clearance from any furniture and fittings of at least 150mm above

the heater, 230mm below and 75mm each side.

Curtains must not be closer than 150mm from the top of the

heater.

Fig. 3 shows the required drill hole positions. Using a straight

edge draw a horizontal line for the top brackets at the required

mounting height from the floor. On this line mark off the fixing

centres at 497mm.

Fix the two top retaining brackets to the wall, using

suitable fixings. Ensure that suitable fixings are placed in both

of the fixing holes provided in each bracket.

Locate the heater on the top brackets and allow it to hang in

place.

Fit the bottom bracket into the slot in the heater and then let it

rest against the wall. Mark the hole positions.

Remove the heater and drill and plug the holes for the bottom

bracket.

Re-hang the heater with the bottom bracket fitted to the heater

and screw fix the bracket to the wall.

Test that the heater is now securely fixed to the wall.

Note: We recommend that the heater should be wall mounted in rooms

where children may be left unattended. See also 'Important Safety

Advice'.

Operation

Important – Objects or clothing must not be placed on this heater.

Before using the heater ensure that all warnings and

instructions have been read carefully.

When you have completed the installation, plug in and switch on the

power. Two switches on the front panel of the heater control the heat

output.

Both switches illuminated indicate both the the front and back panels

are in operation and the heater is operating at maximum output (1kW) -

see Fig. 4A for CVP1 heater controls and Fig. 4B for CVP1T heater

controls.

Controls

Thermostat

Fig. 3

The Thermostat controls the heat output according to the room

temperature. This ensures that the heater will not produce heat

unnecessarily when the room is warm. To set the temperature you

require, turn the thermostat knob clockwise until the required setting is

reached. Alternatively to heat a cold room quickly, turn the thermostat

knob up fully. When the room has reached the desired temperature,

turn the thermostat knob anti-clockwise until the thermostat just clicks

off. The heater will now automatically operate at this temperature. The

thermostat also has a frost protection setting marked '

is useful in areas such as garages, to prevent frost damage. If the

thermostat is set to its minimum setting '

and off to maintain a temperature of approximately 5° to help protect

against frost.

Heat Selector Switches

Top Switch - The top switch controls the back panel element. When

this switch is illuminated this indicates that the 450W oil panel element

is on.

Bottom Switch - The lower switch is used to control the front panel

element.

indicates that the 550W front panel element is on.

Timer (CVP1T model only)

Note: At least one switch must be in the 'On' position for the heater to

operate. - see 'Digital Timer Operation'.

When

the

lower

switch

Thermostat

Heat Selector

Switches

Fig. 4A

Thermostat

Heat Selector

Switches

Timer

Fig. 4B

'. This setting

', the heater will cycle on

illuminated

this