- ページ 7

ツール CRRC MS-ZD20SのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CRRC MS-ZD20S 9 ページ。 Battery installation tool

眉山中车紧固件科技有限公司

Tool Nose Assembly

A.（b）Limit fixing sleeve（a）Fixing sleeve（d）Limit sleeve（i）Connecting shaft（c）Adjusting sleeve

B. The nose assembly equipped with anvil shall be installed on the tool which has been equipped with jaw, the operator shall pay

attention to the connection between limit sleeve (d) and connecting shaft (i), then, put the fixing sleeve (a) into adjusting sleeve (c)

and tighten by wrench. The limit fixing sleeve (b) shall be installed on the nose assembly after the grip range is successfully

adjusted.

Adjusting Rules

A. （a）Fixing sleeve（b）Limit fixing sleeve（c）Adjusting sleeve (d) Limit sleeve

B. To refer the following picture: The scale value (0-4) on limit sleeve (d) represents the grip range (adjusting to

No.2 scale value means the grip range is 2mm). The operations are as follows: The limit fixing sleeve (b) shall be

rotated along anticlockwise direction and the adjusting sleeve (c) shall be rotated along clockwise direction and

limit sleeve (d) will move inward (the scale value will be changed gradually from 0 to 4, on the contrary, if the

adjusting sleeve is rotated along counterclockwise direction, the value will be changed gradually from high to

low). After the scale is confirmed, the limit fixing sleeve (b) shall be rotated along anticlockwise direction to

connect firmly with fixing sleeve (a), and the grip range can not be changed when tightening.

Note: The grip range is from 0 to 5mm (carrying out the riveting operation only within the adjusting range

from 0 to 5mm), if the operation exceeds the grip range, the tool will be damaged. Therefore, please do not

exceed the allowable grip range and do not press the tool switch to adjust the grip range!