- ページ 6

トランシーバー CRT SuperStarのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。CRT SuperStar 11 ページ。 Am/fm/usb/lsb/cw amateur mobile transceiver with built-in frequency counter

ページを印刷する

REAR PANEL

1. ANTENNA : This jack accepts 50 ohms coaxial cable with a PL-259 type plug.

2. DC POWER : This accepts 13.8V DC power cable with built-in fuse. The power

cord provided with the radio has a black and red wire. The black goes to negative

and red goes to positive.

3. EXT. SP : This jack accepts 4 to 8 ohms, 5 watts external speaker. When the

external speaker is connected to this jack, the built-in speaker will be disabled.

4. CW. KEY : This jack is for Morse Code operation. To operate, connect a CW Key

to this jack and place the Mode Control in the CW position.

PROCEDURE TO RECEIVE AND TRANSMIT

A. MICROPHONE

The receiver and transmitter are controlled by the push-to-talk switch on the

microphone. Press the switch and the transmitter is activated, release switch to receive.

When transmitting, hold the microphone two inches from the mouth and speak clearly

in a normal voice. This transceiver comes complete with a low impedance dynamic

microphone.

- DC 13,8V +

B. PROCEDURE TO RECEIVE

1. Be sure that power source, microphone and antenna are connected to the proper

2. Turn VOL knob clockwise to apply power to the radio.

3. Set the VOL for a comfortable listening level.

4. Set the MODE switch to the desired mode.

5. Listen to the background noise from the speaker. Turn the SQ knob slowly

6. Set the CHANNEL selector switch to the desired channel.

7. Set the RF GAIN control fully clockwise for maximum RF gain.

8. Adjust the FINE/COARSE control to clarify the SSB/CW signals or to optimize

C. PROCEDURE TO TANSMIT

1. Select the desired channel of transmission

2. Set the MIC GAIN control fully clockwise.

3. If the channel is clear, depress the push-to-talk switch on the microphone and speak

connectors before going to the next step.

clockwise until the noise just disappears. The SQ is now properly adjusted. The

receiver will remain quiet until a signal is actually received. Do not advance the

control too far or some of weaker signals will not be heard.

AM/FM signals.

in a normal voice.