- ページ 7

ストレージ CRU RAX RAX212-SJのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CRU RAX RAX212-SJ 9 ページ。 2-bay

CRU

a) Right-click on My Computer, then select Manage. The Computer Management window will open.

b) In the left pane of this window, left-click on Disk Management.

c) The drive should appear in the list of Disks in the lower middle/right pane (see picture below). You

may need to scroll down to see it. If the drive is already formatted, you can identify it easily by its volume

name. If it's unformatted, the Drive Properties Box will say "Unallocated" and you'll need to initialize the

disk before formatting it. Initialize the disk by right-clicking the Device Properties Box and selecting

Initialize Disk.

Device

Properties

Box

d) To format the drive, right-click the Drive Properties Box and select Format.

e) If you are prompted to select a partition type, select MBR for volumes 2TB or smaller, or GPT for

volumes larger than 2TB. Note: Windows XP does not support GPT or volumes larger than 2TB.

f) Click through several more windows, leaving the default settings, until you see a window that allows

selection of a file system. Choose NTFS and enter a name for the new volume. Be sure to check the box

labeled "Perform a quick format" unless you want to completely erase any data on the drive and have

time to wait. A quick format should take less than a minute, while standard formatting may take several

hours.

g) Click "Next" and then "Finish" to start the format process. When the format is complete, the Drive

Properties Box will update to show the new volume name. The new volume can now be found in My

Computer.

4.2.3 Mounting and ejecting volumes

If the hard drives attached to RAX are already formatted, you can begin

using the volume right away. When the unit is properly connected and

turned on, a window may open to allow you access to the volume. If no

window appears, you can find the volume by double-clicking "My Computer."

Eject the RAX before powering it down by single-clicking the green arrow icon on

the task bar, then selecting "Safely remove...." Windows will indicate when it is

safe to disconnect RAX. Disconnecting the unit without first ejecting it can result in data loss.

U s e r M a n u a l f o r 2 - B a y R AX ( A9-210-0008) REV 1.0

Drive

Properties

Box

- 7 -