コンピュータ・アクセサリー CRU Dataport DE200 ATA/133のPDF インストールマニュアルをオンラインで閲覧またはダウンロードできます。CRU Dataport DE200 ATA/133 2 ページ。

ページを印刷する

Data Express DE200 ATA/133 Install Guide

Removable Ultra ATA/133 Drive Enclosure

Cable Cover

(provided)

Disk Drive

(not included)

I/O Cable

Power Cable

Receiving Frame

Motherboard

Receiving

Frame

Drive Installation Overview

Master/Slave Selection Jumper (J5)

Master Drive configuration (Factory Default). Forces master drive

configuration on receiving frame. Change jumper to set slave

drive configuration.

Device Spin Down/Up Timer (J6)

Jumper installed (Factory Default) enables device spin down/

up visual indicator. Receiving frame unit ID number display will

flash to indicate device spin down/up.

Slave Drive

Select (1)

DC Power

Master Drive

Select (0)

(Factory Default)

Receiving Frame Motherboard (Rear View)

Drive

Carrier

#6-32 Phillips

F.H. Screw

(6 total)

Device Spin Down/Up Jumper (J6)

On (factory default) = Device Spin

Down/Up Activity Indicator Enabled

Off = Device Spin Down/Up

Activity Indicator Disabled

= Pin 1

1-800-260-9800

Rugged, Reliable, Mobile, Secure

Master/Slave Configuration Jumper J5 (Receiving Frame

Motherboard)

In most cases, the drive will be factory-configured as a Master

Ultra ATA133 drive using a jumper plug on the drive itself. No

configuration changes are required. For multiple drive configura-

tions, it is necessary to set the first Ultra ATA133 drive as Master

and the second Ultra ATA133 drive to Slave. This can be done

by changing the jumper on the Ultra ATA133 drive itself (refer to

your drive manufacturer documentation for further information).

Select the Master/Slave configuration on the rear of the receiving

frame by placing a jumper on the appropriate J5 pins. Remove the

jumper if you wish to use the Unit ID Select switch on the receiv-

ing frame to configure the Master/Slave drive selection.

NOTE: The unit ID select switch configures the unit ID

number display only. The master/slave setting must be set

on the drive itself (refer to the drive manufacturer's docu-

mentation for further information).

Drive Activity Indicator

Connector (J5)

Drive Carrier Circuit Board