ドッキングステーション CRU Dataport DataPort 25のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。CRU Dataport DataPort 25 2 ページ。 Raid dock
ページを印刷するDataPort 25 RAID Dock
Package Contents
1 - DataPort 25 USB/SATA to RAID Dock
1 - DataPort 25 Dual Drive SATA RAID Carrier
1 - Screw kit
1 - Power Adapter Cable
2 - Keys
RAID Configuration
The DataPort 25 RAID Dock operates in four different configurations.
The configuration is determined by the switch settings on either the
back of the frame (see table 1) or the carrier board (see table 2). To
change the configurations set the dip switches to the desired configura-
tion, then cycle the power on the DataPort 25.
NOTE: When configuration is set on frame the carrier switches
must be set to off and when the configuration is set on carrier the
frame switches must be off and the jumper removed.
NOTE: When changing configurations or setting up a new pair of
drives, the power must be cycled on the DataPort 25.
NOTE: The SATA Host Bus Adapter must support SATA port
multipliers for the DataPort 25 RAID Dock to use JBOD. Please
check Silicon Image's website (http://www.siliconimage.com) for
supported cards.
The four configurations are:
1) Concatenated (two drives capacity together as a single drive -
twice the size of the smallest drive)
2) JBOD
3) RAID 0
4) RAID 1
Concatenated
JBOD
RAID 1
RAID 0
NOTE: On the back of the frame board is jumper block J3. If the
jumper is on J3 and the frame is configured as RAID 1, the RAID
will rebuild every time the power is cycled. Remove the jumper
to allow the RAID to power on without rebuilding.
Position 1
Position 2
On
Off
Off
Off
Off
On
On
On
Table 1
Rugged, Reliable, Mobile, Secure
Position 1
Concatenated
JBOD
RAID 1
RAID 0
NOTE: If Position 3 is "On" the RAID will rebuild every time the
power is cycled.
Figure 2: Carrier Drive Side
Connecting the DataPort 25 RAID Dock
Connect the DataPort 25 RAID Dock to any available USB or eSATA
port. No new drivers are required. The hard drives will be found and a
window will pop up stating that new hardwear has been detected. If
the hard drives have been formatted they will be accessible through My
Computer on PCs or from the desktop on Macs.
1-800-260-9800
J3 Jumper
Figure 1: Back of frame
Position 2
On
Off
Off
Off
Off
On
*See note below
On
On
Table 2
Carrier Dip
Switch
www.CRU-DataPort.com
TM
J3
Off
Off
Off