- ページ 10

アンプ Crunch GTS1100のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Crunch GTS1100 13 ページ。 Class ab monoblock amplifier gts series

Interconnect cable checklist:

• Connect the INPUT of the amplifier to the head unit line output with good quality RCA to RCA cables.

• Connect the Subwoofer with the terminal block (SPEAKER OUTPUT/ - +) of the amplifier.

•-The minimum final speaker impedance should not be lower than 1 Ohms. Too low speaker loads result in too high heat

•

dissipation and may cause the amplifier run into protection.

• Please observe speaker channel and polarity as printed by the speaker terminal block. Incorrect phasing of the speakers

•

results in total loss of bass response.

Connect cable from REMOTE CONTROL

with the input jack of the amplifier.

0dB

18dB

Connect the RCA cable from head-unit

or a additional multichannel-amplifier

with RCA input

The optional RCA Fullrange Outputs

(OUTPUT) forwarding the audiosignal.

Please do not connect any speaker (-) to the ground or vehicle chassis.

INPUT LEVEL

• Turn the INPUT LEVEL control on the amplifier to 5V position.

• Turn the head unit volume control to about 80-90% of its full setting.

• Turn the INPUT LEVEL control clockwise until you hear some distortion.

• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.

LOWPASS

• The lowpass filter eliminates the higher frequencies. The recommended crossover frequency ranges between 60 -

•

100Hz, depending on the size and response of the Subwoofer.

SUBSONIC

• The Subsonic filter sets the lower cut-off frequency and protects the Subwoofer from damage. The recommended

•

subsonic frequency ranges between 15 - 40Hz, depending on the size and response of the Subwoofer.

BASS BOOST

• The BASS BOOST - Control increases the bass level at 45 Hz max. +12dB.

Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.

Amplifier - Applications

CAUTION!

Subwoofer 1 - 8 Ohms

You can connect a additional

subwoofer with the free speaker

outputs. But please observe the

correct speaker impedance.