- ページ 5

アクセサリー Aeon AEOTEC GEN5のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aeon AEOTEC GEN5 8 ページ。 Door window sensor

23-2-2017

If you are using double-sided tape, wipe the two surfaces clean of any oil or dust with a damp towel. When the surface

has completely dried, peel one side of the tape back and attach it to the corresponding section on the rear side of the

mounting plates.

Adding your Sensor to your Z-Wave network.

With your mounting plates prepared to hold each component of your sensor, it's time to add it to your Z-Wave network.

1. Let your Z-Wave primary controller/gateway enter into adding/inclusion mode.

2. Take your Sensor near to your primary controller.

3. Press the Action Button once on your Sensor.

4. If your Door Window Sensor has been successfully added to your Z-Wave network, its Status LED will fast blink for

2 seconds and then be solid for 2 seconds when you press the Action Button again. If the adding was

unsuccessful and the Status LED continues to fast blink for 8 seconds and then slow blink for 3 seconds, repeat

the above steps.

https://aeotec.freshdesk.com/support/solutions/articles/6000159782-door-window-sensor-gen5-user-guide-

Door Window Sensor Gen5 (User Guide) : Aeotec by Aeon Labs

5/8