- ページ 5

水ポンプ Arion KRF110-01のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Arion KRF110-01 7 ページ。 Dry pump

4. Precautions

(1)

Observe precautions, and operate the product within specifications.

(2)

Read the instruction manual prior to installation, operation, maintenance and inspection

of the product. Especially pay attention to safety.

(3)

The vanes may get damaged if the residual pressure reverses the rotation when the pump

stops. A check valve must be installed within 50 cm from the inlet port or exhaust port for

protection.

(4)

Be sure to install the product horizontally on the flat surface.

(5)

Operating the product in an enclosed space may cause malfunction due to heat generated

from the pump. Provide good ventilation around the product, so the ambient temperature

does not exceed the permissible level.

(6)

Be sure to clean the filters periodically. Failure to do so may cause clogging and result in

trouble due to overload.

(7)

Wiring work has to be performed by qualified personnel according to applicable laws and

in-house regulations.

(8)

Be sure to install an overload protection such as a thermal relay in the electric circuit.

(9)

Be sure to use the product 1,000m or below above sea level.

(10)

Adjust Alignment (less than 0.3 mm) correctly when install the motor onto the Pump.

Under the miss-alignment operation, it may cause abnormal noise with vibration then

damaged.

(11)

The permitted rotational speed is 750〜1140 rpm. Please use it in this range.

5. Accessories

There is no accessory.

−4−

Spec.No. KRF110-01E