- ページ 5

電気ヒーター Dimplex EMC4240のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dimplex EMC4240 16 ページ。 Construction heaters
Dimplex EMC4240 にも：オーナーズマニュアル (9 ページ), インストレーション・インストラクション (2 ページ), インストレーション・インストラクション (2 ページ)

Grounding Instructions

This heater is for use on 240 Volts.

The cord has a plug as shown on

Figure 1. No adapter should be

used with this unit. The type outlet

is a 240 Volt grounding outlet. When

properly installed, it provides a ground

connection through the cord to the

heater to protect the operation from

electric shock.

Heater Location And

Clearances

The heater is intended for use

located on a hard floor, table top,

desk or on shelf, and the like.

The discharge air should wipe the

walls without blowing directly on

them (Figure 2).

Ensure the air discharge is

parallel to or away from walls.

! NOTE: To prevent personal

injury always use a licensed

electrician to install new

outlets or circuits.

CAUTION: When turning and/or tilting the heater do not block the

exhaust opening.

Use Of Support Stand (EMC4240 only)

The pre-installed support stand can be swivelled out to allow an

upward angle for the air discharge. When in down position, the heater

should be placed on a flat surface such that it will be stable and not fall

over (Figure 3).

Figure 1:

Plug and outlet

configuration for 240

Volt, 30 Amp circuit

Plug

Figure 2

Outside Wall

Ground

Outlet