- ページ 5

アクセサリー Aeon Labs AEOEZW100のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aeon Labs AEOEZW100 11 ページ。 Routing multisensor

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user

needs or unlock further enhanced features.

IMPORTANT: Controllers may only allow to configure signed values. In order to set values in the range 128 ... 255 the value sent in the

application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of 200 minus 256

= minus 56. In case of two byte value the same logic applies: Values greater than 32768 may needed to be given as negative values too.

Enable/Disable waking up (Parameter Number 2, Parameter Size

mode) the MultiSensor.

Value

default PIR time (Parameter Number 3, Parameter Size

(0x00) to the associated nodes if no motion is triggered again in 4 minutes.

Value

Description

10 —

The time unit is second if the value range is in 10 to 255. Default Value is 240.

255

256 —

If the value range is in 256 to 3600, the time unit will be minute and its value should follow the below rules: a), Interval time =Value/60, if the interval time

3600

can be divided by 60 and without remainder. b), Interval time= (Value/60) +1, if the interval time can be divided by 60 and has remainder. Other values will

be ignored.

Enable/disable the function of motion sensor. (Parameter Number 4, Parameter Size 1)

Value

Description

disable (Default)

enable, the current PIR sensitivity level=1. (minimum level)

1)Enable/Disable waking up for 10 minutes when re-power on (battery

Description

disable (Default)

enable

2)The default PIR time is 4 minutes. The Multisensor will send BASIC SET CC