電気ヒーター Dimplex RKHAのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dimplex RKHA 4 ページ。 Under cabinet heater
Dimplex RKHA にも: インストレーション・インストラクション (2 ページ), オーナーズマニュアル (3 ページ), 取扱説明書 (10 ページ), マニュアル (4 ページ)
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the heater.
2. The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater
outlet becomes hot during heater operation. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains at least 3 ft (0.9 m) from the front of the unit and keep them away from the sides
and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the unit is
left operating and unattended.
4. Do not operate any heater after it malfunctions. Disconnect power at the service panel and have the heater
inspected by a reputable electrician before reusing.
5. Do not use outdoors.
6. To disconnect the unit, turn the controls off, and then switch off at main power supply panel.
7. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric
shock or fire, or damage to the heater.
8. To prevent a possible fire, do not block air intake or exhaust in any manner.
9. All electrical heaters have hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or
flammable liquids are used or stored.
10. Do not modify this heater. Use it only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
Installation Instructions
WARNING: To reduce the risk of fire, do not store or
use gasoline or other flammable vapors or liquids in the
vicinity of the heater.
CAUTION: High temperature, risk of fire, keep
electrical cords, drapery, furnishings, and other
combustibles at least 3 feet (0.9 m) from the front of
the heater.
NOTE: It is extremely important to read all information
!
labels. Care must be taken to ensure that the heater
is rated the same voltage as the electrical supply
wires. Failure to do so could result in unsafe heater
operation as well as damage to the unit. If replacing
an existing heater, check the labels of the old heater
to ensure the voltage of the new heater is compatible.
NOTE: Care must be taken to prevent undue strain on
!
all wiring or heating element assembly, when removing
and re-assembling heating element assembly.
SAVE THESE INSTRUCTIONS
Under Cabinet Heater
RKHA Series
CAUTION: For field rewiring to 120V all leads must
be secured under wire clamps.
! NOTE: Air and grille temperatures conform to CSA & UL
regulations but may discolour certain materials, particularly
those materials incorporating clear vinyl. Materials should be
checked prior to installation to determine if discolouration or
distortion would occur in the vicinity of 60° C (140° F)
Under Cabinet Heater Installation
NOTE: Unit should be installed so that it is not
!
directly under sink or other frequently used work area
as air temperature may be uncomfortably warm. Also,
if carpeting is on floor, mount unit so bottom of grille is
level or above the top of the carpet pile.
1. Measure area of intended use. The optional grille
trim may be used if required. Otherwise the frame
may be removed by removing grille frame from
heater (screw "A"), remove frame and re-insert grille.
7200960100R012