電気ヒーター Dimplex XLS12NのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Dimplex XLS12N 8 ページ。 Ultra-slim storage heaters
Dimplex XLS12N にも：取扱説明書 (10 ページ), 操作説明 (4 ページ), 取付説明書 (8 ページ), 操作説明 (4 ページ), 取付説明書 (8 ページ)

ページを印刷する

Dimplex Ultra-Slim Storage Heaters

Models XL12N, XL18N, XL24N

Twin Sensor Models XLS12N Automatic,

XLS18N Automatic, XLS24N Automatic

IMPORTANT

These instructions should be read carefully and retained for future reference.

Note also the information given on the appliance.

This heater is VERY HEAVY. In order to maintain

stability and to ensure its future safety in use, it is

essential that the heater is FIXED SOUNDLY TO A WALL

and that the feet are mounted on a FIRM, LEVEL

SURFACE. Care should be taken to avoid irregular

surfaces, such as may result from tiled surrounds

partially protruding under the heater. It is important

that the following instructions are strictly followed.

IT IS IMPORTANT THAT THE FIXING DEVICE CHOSEN

IS APPROPRIATE TO THE WALL MATERIAL TO WHICH

THE HEATER IS BEING FIXED. SOME MODERN

INTERNAL BUILDING MATERIALS ARE VERY LOW

DENSITY BLOCK AND REQUIRE SPECIALISED FIXING

DEVICES TO PROVIDE A SAFE, SECURE

INSTALLATION.

Connection to a 30 amp Ring Circuit

XLN/XLSN STORAGE HEATERS SHOULD NOT BE CONNECTED TO A 30 AMP RING CIRCUIT.

XL/XLS24N STORAGE HEATERS SHOULD NOT BE CONNECTED TO A FUSED SPUR.

Bricks are in packs of two.

The pack catalogue number is XT 8300

XL12/XLS12N - 12kWh

8 Bricks (4 Packs)

This appliance complies with the European Standards EN 60 335-1, EN 60 335-2-61, EN 61000-3-2, EN 61000-3-3, EN 55014 and EN55104 for Safety & Electromagnetic Compatibility.

Installation Instructions

The installation of this appliance should be carried out by

competent personnel and be in accordance with the current

IEE wiring regulations. For the assembly of the heater tools

required are a No. 2 pozidriver, an electrical screwdriver with a

4mm wide blade and a 8mm AF open ended or box spanner.

A small mirror will aid insertion of the front panel retaining

screws.

Only Heat Resisting Cable (min. rating T85) should be used.

DO NOT COVER OR OBSTRUCT the surfaces of the

appliance.

DO NOT POSITION under windows where curtains may

contact the heater. (See minimum clearances, stage 6).

DO NOT PLACE OBJECTS in contact with the heater.

If, during any reassembly of the heater, a part of the thermal

insulation shows damage or deterioration which may impair

safety, it should be replaced with an identical part.

XL18/XLS18N - 18kWh

12 Bricks (6 Packs)

These standards cover the requirement of the EMC Directives 89/336 & 73/23

XL24/XLS24N - 24kWh

16 Bricks (8 Packs)

(96513 Iss. 12)