- ページ 7

扇風機 Dimplex DCPF40CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dimplex DCPF40C 10 ページ。 40cm hv pedestal fan
Dimplex DCPF40C にも：取扱説明書 (9 ページ)

Assembly

1. Remove the pole fixing nut (16) from the main pillar (14) and insert the main pillar

(14) into the base (15) then tighten the fixing nut (16).

2. Release fixing screw B (13) and adjust height to a suitable length. Re-tighten the

fixing screw B once ready.

3. Release the fixing screw A (11), connect the motor housing with the upper pillar

(12), fasten it with the fixing screw A (11).

4. Remove the blade locking cap (2) and the guard knob (4) from the motor shaft

(6), secure the rear guard (5) on the motor housing (9) to line up with the three

fixing pins, fasten the guard with the guard knob (4).

5. Put the blade (3) on the motor shaft (6) and tighten with the blade locking cap

(2).

6. Attach the front guard (1) to the rear guard (5), and close the guard fixing clips,

finally fastening with the safety screw (17)

Operation

1. Connect the plug to a power supply and switch on the power.

2. Switch the fan ON by rotating the speed control knob (7) at the rear in clockwise

direction.

3. The switch is also used to adjust the fan SPEED.

4. The airflow direction can be adjusted upward/downward by lifting up or pressing

down the motor housing.

NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your

fingers through the guard.

5. Push the oscillating knob (8) down to start OSCILLATION. Pull the oscillation

knob up to stop OSCILLATION.

6. Turn speed control knob (7) to adjust the fan speed from LOW "1" – MEDIUM "2"

- HIGH "3" in sequence. Turn the switch anti-clockwise to the "0" position to turn

OFF.

7. Turn the switch anti-clockwise to the "0" position to turn the fan OFF. Speed