- ページ 20
カーレシーバー Pioneer AVH3850DVDのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Pioneer AVH3850DVD 27 ページ。 Dvd av receiver
ページを印刷する
Connection/Installation
Installation
Notes of installation
• B efore installation, please make sure proper connections
are conducted and the unit operates normally. Improper
connection may result in damage to the unit.
• U se only accessories designed and manufactured for this
unit and other unauthorized accessories may result in
damage to the unit.
• B efore installation, please fasten all power cables.
• D O NOT install the unit in the place where close to hot area
to prevent damage to electrical components such as the
laser head.
• I nstall the unit horizontally. Installing the unit more than 30
degree vertically may result in worse performance.
• D O NOT block the cooling fan exit to ensure sufficient
heating dissipation of this unit, or it may result in damage to
this unit.
Leave ample
5 cm
space
5 cm
5cm
Unit Installation
Method A
1. Insert mounting bracket into dash board, choose appropriate
mounting tab according to the gap width, bending the
mounting tab outwards with a screwdriver to fix the mounting
bracket in place.
2. Use 2 pieces of M5×5 cone shaped screw to fix two
assemble bars on both sides of the unit. (see picture 1)
Long Assemble
Bar
M5 X 5
20
(Picture 1)
Dashboard
Mounting Bracket
Long Assemble Bar
(Picture 2)
3. Insert the unit into the bracket, and use 4 pieces of M2×2
screw to lock the assemble bars and the mounting bracket in
position.
Note:
According to the depth of the opening, use different position of M5
screw holes on the unit accordingly. If the opening is too shallow, the
monitor may be extended out 10mm from the dashboard.
Method B
1
1
Mounting Frame
1. Insert this unit directly to the opening of the dashboard.
2. Place M4×3, M5×5 cylindrical screw or M5×5 cone shaped
screw through the holes of the mounting frame located inside
the opening to holes of the unit and fasten the screws to left
& right.
Trim Ring installation
Attach the trim ring around the front panel with two indentions
on one side facing upwards
Uninstall
Disassemble trim ring
1. Push the trim ring upward and pull out the upper part.
M2 X 2
2. Push the trim ring downward and pull out the lower part.
M5 X 5
Disassemble the unit
1. Unscrew the 4 pieces M2×2 screws.
2. Use a screwdriver to bend straight the bended mounting tab
and tip out the unit from the mounting bracket.
Dashboard
3. Pull out the unit from the mounting bracket with both hands.