- ページ 32

カーレシーバー Pioneer CDX-M1026ZGのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Pioneer CDX-M1026ZG 45 ページ。 Multi-compact disc player

ページを印刷する

CDX-M1026ZG

6.2 CD ADJUSTMENT

1)Precautions

• This unit uses a single power supply (+5V) for the reg-

ulator. The signal reference potential, therefore, is

connected to REFO(approx. 2.5V) instead of GND.

If REFO and GND are connected to each other by mis-

take during adjustments,not only will it be impossible

to measure the potential correctly,but the servo will

malfunction and a severe shock will be applied to the

pick-up. To avoid this,take special note of the follow-

ing.

• Do not connect the negative probe of the measuring

equipment to REFO and GND together. It is especially

important not to connect the channel 1 negative

probe of the oscilloscope to REFO with the channel 2

negative probe connected to GND.

Since the frame of the measuring instrument is usual-

ly at the same potential as the negative probe,change

the frame of the measuring instrument to floating sta-

tus.

If by accident REFO comes in contact with

GND,immediately switch the regulator or power OFF.

• Always make sure the regulator is OFF when connect-

ing and disconnecting the various filters and wiring

required for measurements.

• Before proceeding to further adjustments and mea-

surements after switching regulator ON,let the player

run for about one minute to allow the circuits to sta-

bilize.

• Since the protective systems in the unit's software are

rendered inoperative in test mode,be very careful to

avoid mechanical and /or electrical shocks to the sys-

tem when making adjustment.

• This unit is adjusted in a combination with the CD con-

troller tool(CEP-323). Each regulator key should be

operated at the unit.

With the CEP-323 taken up for reference, a descrip-

tion will be given below concerning how to enter into

the test mode, including key operations. The key in

the adjustment text is also one of the CEP-323 keys.

• How to enter into the test mode

1. Setup the POWER switch ON and PMM switch

RUN of CEP-323.

2. DC Regulated Power Supply power ON.

3. Pressing the RESET switch of CEP-323.

4. Wait for 10 seconds.

5. Pressing the TESTIN switch of CEP-323.

6. Insert the magazine assy.

• Resetting the test mode

DC Regulated Power Supply power OFF.

• Disc detection during loading and eject operations is

performed by means of a photo transistor in this

unit.Consequently,if the inside of the unit is exposed

to a strong light source when the outer casing is

removed for repairs or adjustment,the following mal-

functions may occur.

*During PLAY, even if the eject button is pressed,the

disc will not be ejected and the unit will remain in

the PLAY mode.

*The unit will not load a disc.

When the unit malfunctions this way,either re-posi-

tion the light source,move the unit or cover the

photo transistor.

• When loading and unloading discs during adjustment

procedures,always wait for the disc to be properly

clamped or ejected before pressing another key.

Otherwise, there is a risk of the actuator being

destroyed.

• Turn power off when pressing the button TR+ or the

button TR- key for focus search in the test mode. (Or

else lens may stick and the actuator may be dam-

aged.)

• SINGLE/4TRK/10TRK/32TRK will continue to operate

even after the key is released.Tracking is closed the

moment C-MOVE is released.

• JUMP MODE resets to SINGLE as soon as power is

switched off.