- ページ 3

カーレシーバー Pioneer DEH-P3370XM UCのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Pioneer DEH-P3370XM UC 4 ページ。 Pioneer deh-p3370xm: install guide

ページを印刷する

Installation

Note:

• Before finally installing the unit, connect the

• When mounting this unit, make sure none of the

wiring temporarily, making sure it is all connected

leads are trapped between this unit and the sur-

up properly, and the unit and the system work

rounding metalwork or fittings.

properly.

• Do not mount the tuner unit near the heater outlet,

• Use only the parts included with the unit to ensure

where it would be affected by heat, or near the

proper installation. The use of unauthorized parts

doors, where rainwater might splash onto it.

can cause malfunctions.

• Before drilling any mounting holes always check

• Consult with your nearest dealer if installation

behind where you want to drill the holes. Do not

requires the drilling of holes or other modifications

drill into the gas line, brake line, electrical wiring

of the vehicle.

or other important parts.

• Install the unit where it does not get in the driver's

• If the tuner unit is installed in the passenger com-

way and cannot injure the passenger if there is a

partment, anchor it securely so it does not break

sudden stop, like an emergency stop.

free while the car is moving, and cause injury or an

• The semiconductor laser will be damaged if it

accident.

overheats, so don't install the unit anywhere hot

• If the tuner unit is installed under a front seat,

— for instance, near a heater outlet.

make sure it does not obstruct seat movement.

• If installation angle exceeds 60° from horizontal,

Route all leads and cords carefully around the slid-

the Head Unit might not give its optimum perfor-

ing mechanism so they do not get caught or

mance. (Fig. 5)

pinched in the mechanism and cause a short cir-

cuit.

Fig. 5

DIN Front/Rear-mount

This unit can be properly installed either from "Front" (conventional DIN Front-mount) or

"Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit

chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush (Fig. 6)

Holder

After inserting the holder into the dash-

board, then select the appropriate tabs

according to the thickness of the dash-

Dashboard

board material and bend them.

(Install as firmly as possible using the

182

top and bottom tabs. To secure, bend

the tabs 90 degrees.)

Rubber bush

Screw

Removing the Unit (Fig. 7) (Fig. 8)

Fig. 6

Frame

I nsert the release pin into the hole in

the bottom of the frame and pull out

to remove the frame.

(When reattaching the frame, point

the side with a groove downwards

and attach it.)

Fig. 7

Insert the supplied extraction keys

into the unit, as shown in the figure,

until they click into place. Keeping

the keys pressed against the sides of

the unit, pull the unit out.

Fig. 8