- ページ 8
カーレシーバー Pioneer XV-DV535WのPDF 操作説明をオンラインで閲覧またはダウンロードできます。Pioneer XV-DV535W 47 ページ。 Dvd/cd receiver; speaker system; digital; wireless speaker system
ページを印刷する
01
Getting started
Chapter 1
Getting started
Home theater sound setup
In addition to the diagram below, also make
sure to review the supplied setup guide for
more helpful speaker placement guidelines.
This is a standard multichannel surround
sound speaker setup:
Front left
Important
• Placing the transmitter and the wireless
speaker too close together will result in an
unstable signal. Make sure they are more
than 1m apart for the best reception.
• The radio waves sent from the transmitter
to the wireless speaker may reflect off any
number of surfaces in your listening area
(for example, walls or cabinets). If you are
experiencing poor reception due to this
phenomenon, try moving the position of
the transmitter or the wireless speaker for
better reception.
Note
1 The wireless speaker system must be switched on for multichannel surround sound.
2 • This is only available when DVD/CD is selected and playback is stopped. Also make sure headphones are unplugged.
• The speaker volume can be adjusted while listening to any sound source you want: Press SHIFT+SYSTEM SETUP, use the
(cursor left/right) buttons to select the channel level setting, then press ENTER. Use
channel levels;
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
8
En
Center
Front right
Subwoofer
Listening position
Wireless speaker
(cursor left/right) to move to the next channel. Press ENTER when you're finished.
After placing your speakers, switch on the
wireless speaker system
Setting the channel levels below. Refer to
Speakers settings on page 24 to complete your
surround sound setup.
Setting the channel levels
Set the relative channel levels from your main
2
listening position.
1
Press SHIFT+TEST TONE .
The test tone is output in the following order
(from the speakers active in the current
listening mode):
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• SR – Right surround (wireless) speaker
• SL – Left surround (wireless) speaker
3
• SW – Subwoofer
2
Use the VOLUME +/– button to adjust
the volume to an appropriate level.
3
Use the
(cursor up/down) buttons
to adjust the speaker levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
4
When you're done, press ENTER to exit
test tone setup.
1
then complete
(cursor up/down) to adjust the