- ページ 25

カーレシーバー Pioneer YPM-2106ZFのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Pioneer YPM-2106ZF 43 ページ。 Cd players

- Removing the Guide Arm Assy Section

1. Remove a connector, a spring A and B.

2. Drive the Guide Arm Assy up aslant into rear side

direction, then remove it from a Pin. Finally, drive the

assembly approximately 45 degrees upward, then

slide the assembly toward left side to remove it.

Note : When assembling the guide arm assembly, route

the cord inside the assembly. In this operation,

care must be exercised so that cord may be

caught by the gear.

- Removing the LO Arm Assy Section

1. Remove two Pins to dismount the LO Arm Assy.

- Removing the Control Unit and the Spindle

Motor

1. Remove from the connector after mounting the short

pin on the flexible PCB of the pickup unit.

2. Remove two Soldered joints, then remove two

Screws A.

3. Remove two connectors and a Screw B.

4. Disengage the Control Unit from two Tabs, then dis-

mount the unit by sliding it toward left.

5. Dismount the Spindle Motor.

Guide Arm Assy Section

LO Arm Assy Section

Short Pin

Spindle Motor

Control Unit

YPM-2306ZF