- ページ 10

レシーバー Pioneer XV-DV353のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer XV-DV353 50 ページ。 Dvd/cd receiver; speaker system
Pioneer XV-DV353 にも：取扱説明書 (48 ページ)

ページを印刷する

Getting started

Connect the microphone to the MCACC

MIC jack on the rear panel.

The illustration shows the XV-DV353 model.

Place the microphone at your normal

listening position.

Place it about ear height, and make sure it is

level by using a table or chair.

Make sure there are no obstacles between the

speakers and the microphone.

If the system is off, press

STANDBY/ON to turn the power on.

If the tuner is selected, switch the input source.

Press SHIFT+MCACC.

Try to be as quiet as possible after pressing

SHIFT+MCACC. The volume increases

automatically and the system outputs a series

of test tones.

• Press SHIFT+MCACC to cancel and revert

to the previous Auto MCACC settings.

• If the noise level is too high, NOISY blinks

in the display for five seconds. To exit and

check the noise levels

SHIFT+MCACC, or to try again, press

ENTER when RETRY shows in the display.

• If you see an ERR MIC or ERR SP message

in the display, there may be a problem with

your mic or the speaker connections. To try

again, press ENTER when you see RETRY

Note

1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles

blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air condition-

er, fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.

• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during the Auto

MCACC setup.

2 If this doesn't work, press SHIFT+MCACC, turn off the power, and check the problem indicated by the ERR message, then try

the Auto MCACC setup again.

3 If COMPLETE doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.

4 See Listening with Acoustic Calibration EQ on page 15 to switch on/off Acoustic Calibration EQ.

5 The screen saver will appear after five minutes of inactivity.

ANTENNA

COMPONENT

VIDEO

UNBAL75 Ω

AM LOOP

S-VIDEO

MCACC

VIDEO OUT

MIC

CONTROL

, press

When the MCACC setup is complete, the

volume level returns to normal and

COMPLETE

shows in the display, indicating

that the MCACC setup is complete and

Acoustic Calibration EQ has been activated.

Using the on-screen displays

For ease of use, this system makes extensive

use of graphical on-screen displays (OSDs).

All the screens are navigated in basically the

same way, using

highlighted item and pressing ENTER to select

it.

Important

• Throughout this manual, 'Select' means

use the cursor buttons to highlight an item

on-screen, then press ENTER.

Button

What it does

HOME

Displays/exits the on-screen display

Changes the highlighted menu item

ENTER

Selects the highlighted menu item

RETURN

Returns to the main menu without

saving changes

Tip

• The button guide at the bottom of every

OSD screen shows you which buttons

you'll need to use for that screen.

to change the