- ページ 11

ステレオ・レシーバー Pioneer VSX-604SのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer VSX-604S 34 ページ。

CONNECTIONS

IR Repeater connection

Connecting a supplied IR Repeater lets you also control other components with this unit's remote control.

NOTE:

To operate components not made by Pioneer, perform REMOTE SET UP (P. 29) after connecting an IR Repeater.

Remote control signals directed towards this unit or GU! operation signals are transmitted from the repeater as infrared signals,

enabling control of other components.

There are two kinds of infrared repeaters. Connect either or both to match the remote control requirements of different components.

MAIN-REPEATER

Use this to operate other components with this unit's remote

control or to operate using GUI on-screen indications.

Install on top of thus unit as shown in the figure.

) - Insert the REPEATER's

two pegs into the holes on

the top.

Install

the

REPEATER

laying on its side on the top.

MAIN-REPEATER

(ry)

The pegs are usually inserted

in the two rear holes.

Use the two front holes

when

there's another

component on top of this

preventing

easy

reception of the MAIN

REPEATER's

infrared

signals.

Use this when a component operates incorrectly after receiving

a signal from this unit's remote control, or when it is difficult

for a component to receive signals from the Main-Repeater.

NOTE:

Stick it directly on the remote control sensor window.

To prevent possible damage, be careful to avoid accidentally

There are two MINI-REPEATER terminals.

connecting the MINI-REPEATER to the MAIN-REPEATER terminals.

lf you need another Mini-repeater, contact your nearest

Pioneer Service Center.

MINI-REPEATER

fon

SoedeeasnG)

—

(bite

12Q:000

_=—=

ver

VCR

——————

@ Remove the seal.

@ Stick onto the remote control

sensor window.