- ページ 30

ステレオ・レシーバー Pioneer VSX-D411のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer VSX-D411 44 ページ。 Audio/video multi-channel receiver
Pioneer VSX-D411 にも：サービスマニュアル (4 ページ)

ページを印刷する

Setting up the receiver

Use ' or ' to adjust the setting.

The setting is entered automatically.

Repeat steps 3 and 4 to set other

surround modes.

When you're done, press ENTER to exit.

The setting display is automatically exited

after 20 seconds of inactivity.

Speaker setting

• Default setting: S (all speakers)

You must let the receiver know how many

speakers you have, and how big they are. The

size you choose (large or small) determines

how much bass is sent from the receiver to the

speakers.

In the display, F, C, and S refer to front, center,

and surround speakers respectively. Speaker

size is denoted as L for large speakers, S for

small speakers, and (asterisk) if no speaker is

connected.

•

Cycle through the available choices

using ' or ' and choose a configuration

that matches your speaker setup.

One of the following configurations should

match your setup:

FL-C -SS

FL-C -SL

FL-CS-S

FL-CS-SS

FL-CS-SL

FS-CS-SS

FS-CS-S

FS-C -SS

FL-CL-SL

FL-CL-SS

FL-CL-S

• If the cone size (diameter) of the speaker is

larger than 5 inches, set the speaker size

to L.

• If you're not using a subwoofer, we

recommend setting the front speakers to L.

Subwoofer setting

• Default setting: ON

You can choose whether the subwoofer is used

or not. Use the plus (PLS) setting for extra bass.

Use ' or ' to select subwoofer ON, PLS

•

or OFF.

• If you chose the small front speaker

setting, SUBWF ON is automatically set

and locked.

• When you select the plus setting, you will

get the bass sounds from the subwoofer

even if the front speakers are set to L.

Crossover frequency setting

• Default setting: 100 Hz

Crossover frequency is the point where the

receiver divides the high and low sounds (the

frequencies) between the speakers. Since most

smaller speakers can't handle deep bass tones,

you can send these sounds to the subwoofer (or

if you don't have a subwoofer, the large (L)

speakers in your system) instead of the

speakers set to small (S) in your setup. Choose

the point at which you want the frequency

routed to the subwoofer (or L speakers).

We recommend setting this to 200 Hz if your S

speakers are smaller bookshelf-type speakers.

Use ' or ' to specify the crossover

•

frequency for your small speakers (100 Hz,

150 Hz or 200 Hz).