- ページ 12

ステレオ・レシーバー Pioneer VSX-D510のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer VSX-D510 40 ページ。 Audio/video multi-channel receiver
Pioneer VSX-D510 にも：取扱説明書 (36 ページ), サービスマニュアル (14 ページ)

ページを印刷する

Preparations

SPEAKERS (Front, Center, Surround)

setting mode

This setting establishes the configuration of the speaker

system and size of each set of speakers you have

connected. So, for example, here you set whether you

have connected surround speakers or not, and how big

they are. Selecting "Large" or "Small" will determine how

much bass is sent by the receiver to the speakers being

set.

In the display, "F", "C", and "S" refer to front, center,

and surround speakers respectively. Speaker size is

denoted as "

" for large speakers, "S" for small

speakers, and " * " (asterisk) if no speaker is connected.

MEMO:

If the cone size (diameter) of the speaker is larger than

12 cm, please set to Large.

Choose a speaker setting mode according to

the speakers you hooked up. Use the % or ﬁ

buttons.

The configurations shown below will appear in the

display on the front of the receiver. One of them

should match your speaker set up. Cycle through the

different possibilities until you find the one that

matches your set up.

Press # to advance to the next receiver setting, and

press @ to return to a previous receiver setting.

SUBWOOFER ON/PLUS/OFF setting

mode

Sets whether the SUBWOOFER is used or not. Also,

when used you have the option to use the "

setting.

Press % or ﬁ to select subwoofer ON, PLUS

or OFF.

MEMO:

• The initial setting is "

• Setting the front speaker size to "Small" in the

SPEAKERS setting mode automatically locks the

subwoofer in the "

" position.

• Use the

for extra bass. When you use

PLUS

you will get the bass sounds from the subwoofer

even if the front speakers are set to "Large".

Crossover frequency setting mode

Crossover frequency is the point where the receiver

divides the high and low sounds (the frequencies)

between the speakers. Since most smaller speakers can't

handle deep bass tones, this setting allows you to send

those sounds to the subwoofer (or speakers set to

"Large" if you don't have a subwoofer) instead of the

speakers set to "Small" in your system. Choose the point

at which you want the frequency routed to the

subwoofer (or "Large" speakers).

We recommend setting this to 200 Hz if smaller

bookshelf-type speakers are used for your "Small"

speakers.

Press % or ﬁ to specify the crossover

frequency for your small speakers (100 Hz,

150 Hz or 200 Hz).

100Hz

150Hz

200Hz

100 Hz

Sends bass frequencies below 100 Hz to the subwoofer

(or "Large" speakers).

150 Hz

Sends bass frequencies below 150 Hz to the subwoofer

(or "Large" speakers).

200 Hz

Sends bass frequencies below 200 Hz to the subwoofer

(or "Large" speakers).

PLUS