- ページ 5

アンプ Pioneer A-10-KのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer A-10-K 12 ページ。
Pioneer A-10-K にも：取扱説明書 (13 ページ)

ページを印刷する

Connecting up

Chapter 2:

Connecting up

Making cable connections

Caution

• Before making or changing the connections, switch off the power and disconnect the power cord from the AC

outlet.

• Connect the power cord after all the connections between devices have been completed.

SACD/CD player

Network audio player

OUTPUT

Turntable

Tuner

iPod dock, etc

Speaker system B

Right

Left

This unit's rear panel

Power cord

(included)

AUDIO

OUTPUT

PLAY

REC

iPod

Music>

Extras>

Settings>

Shuffle Songs

Backlight







CD recorder or

Right

Left

tape deck

Speaker system A

Caution

• The SIGNAL GND terminal is provided to reduce

noise when connecting the unit to components

such as an analog turntable.

• Do not connect the PHONO (MM) terminals to any

component other than a turntable; also, do not

connect to a turntable equipped with built-in

equalizer. An excessively high sound output may be

produced, resulting in damage to your speakers or

other devices.

• The unit's PHONO (MM) terminals are designed to

be used with turntables equipped with MM

(moving-magnet) type cartridges. Turntables

equipped with MC (moving-coil) cartridges cannot

be used.

• Make sure not to bend the cables over the top of

this unit (as shown in the illustration). If this

happens, the magnetic field produced by the

transformers in this unit may cause a humming

noise from the speakers.

• If your turntable has a grounding wire, secure it to

the ground terminal on this amplifier.

Note

• When connecting a tape cassette deck, playback

noise may be heard, depending on the installation

location. This noise is caused by leakage flux from

the amplifier's transformer. In this event, change

the installation location, or move the deck farther

from the amplifier.

• iPod is a trademark of Apple Inc., registered in the

U.S. and other countries.

About "Bi-wiring"

This unit can be used with speakers that support bi-

wiring. Be sure to connect the high-frequency and

low-frequency connections correctly.

• During playback, be sure that both the SPEAKERS

A button and SPEAKERS B button are set to ON

(page 7).

Speaker system

Left

Right

Remove the shorting

bar between the +

and – terminals.

HIGH

LOW

This unit's

rear panel

Caution

• When using bi-wiring to connect speakers, avoid

adverse affects on the amplifier by being sure to

remove the HIGH and LOW short bars provided

with the speakers. For detailed information, consult

the instructions provided with the speakers.

• When using speakers with removable network

circuits, note that if the network is removed, no

effect will be produced and damage may be caused

to the speaker.

• Another method of connection is to connect the

SPEAKERS A terminals to HIGH and the

SPEAKERS B terminals to LOW (reverse that shown

in the illustration).