ページを印刷する
FEATURES .....s.cssseesereeeeeeee
2
CONNECTIONS ....
2:
PANEL FACILITIES
4
CONTENTS
OPERATIONS .
TROUBLESHOOTING
SPECIFICATIONS...
FEATURES
* Drive capacity 85 W + 85 W/4 Q (DIN) matching to high power and
jow impedance type speaker system.
[model A-300 .......e eeeceerseeeseeeeeeneee 60 W + 60 W/4 @ {DIN}}
* The use of a Super Linear Circuit assures high fidelity playback of
consistent frequency characteristics, accompanied
by maximum
clarity.
* Clean ground technology prevents noise on power line to flow to the
signal ground line, permitting clean sound reproduction.
* REC selector switch makes tape editing very simple.
CONNECTIONS
* Comes with a built-in phono equalizer which accepts MC cartridges.
{A-400 only)
* Honeycomb Chassis, Honeycomb Heat Sink (Thorough anti-vibration
construction).
. CONNECTING THE SPEAKER CORDS
1. Strip off the vinyl covering and twist the tip of the wire core.
@
Twist the wire core.
2. Loosen the knob and insert the wire core into the terminal hole.
3. Tighten the knob to fix the wire core in place.
@
@
o- 4. E
is
Using banana plugs
As shown in the diagram, insert the plugs ail the way into the holes
in the ends of the speaker terminals.
4,
{Example: right channel]
Speaker cord
NOTE:
Do not allow the wire core to protrude and touch other terminals or
wires. ff the cores of differing wires touch, damage may be caused to
your amplifier and/or speaker systems.
3
2
<ARBI247>
Speaker Impedance
The speaker systems are connected to only SPEAKERS terminals, such
speakers should have rated impedance in the range of 4 - 16 9.
CONNECTING THE Input/Output CORDS
Connect the white plug to the L {left} side, and the red plug to the R
{right} side, Be sure to insert the plugs in securely.
.
Left channel
White plug
~~
Right channel
~~ a
Cite
LEER
Red plug
The Input/Output jacks of this unit are dull tinplated, aiming at high audio
quality.