- ページ 21

アンプ Pioneer Elite SX-A6-JのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer Elite SX-A6-J 24 ページ。 Pioneer stereo receiver operating instructions
Pioneer Elite SX-A6-J にも：仕様書 (2 ページ)

ページを印刷する

1. Specifications

Additional information

Chapter 7:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Sometimes the trouble may lie in

another component. Investigate the other components and electrical appliances being used. If the

trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer

authorized service center or your dealer to carry out repair work.

• If the unit does not operate normally due to external effects such as static electricity

disconnect the power plug from the outlet and insert again to return to normal operating

conditions.

Problem

The power does not turn on.

No sound is output when a

function is selected.

Considerable noise in radio

broadcasts.

Broadcast stations cannot be

selected automatically.

Noise during playback of a

cassette deck.

Can't operate the remote

control.

Remedy

• Disconnect the power plug from the outlet, and insert again.

• Make sure there are no loose strands of speaker wire touching the rear

panel. This could cause the receiver to shut off automatically.

• If you're trying to switch on using the remote control, make sure the

front panel POWER button is switched on first.

• If the power shuts off automatically, take the unit to your nearest

Pioneer authorized service center or your dealer for servicing.

• Make sure the component is connected correctly (refer to Connecting

up on page 8).

• Press MUTE on the remote control to turn muting off.

• Connect the antenna (page 9) and adjust the position for best reception.

• Route any loose cables away from the antenna terminals and wires.

• Fully extend the FM wire antenna, position for best reception, and

secure to a wall (or connect an outdoor FM antenna).

• Connect an additional internal or external AM antenna (page 9).

• Turn off equipment causing interference or move it away from the

receiver (or move antennas farther away from equipment causing noise).

• Connect an outdoor antenna (refer to page 9).

• Move the cassette deck further from your receiver, until the noise

disappears.

• Replace the battery (refer to page 7).

• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel

(refer to page 12).

• Remove the obstacle or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.