- ページ 11

アンプ Pioneer GM-D8601のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Pioneer GM-D8601 45 ページ。 Class d mono amplifier
Pioneer GM-D8601 にも：オーナーズマニュアル (15 ページ), オーナーズマニュアル (49 ページ)

ページを印刷する

Installation

Before installing the amplifier

WARNING

! To ensure proper installation, use the supplied

parts in the manner specified. If any parts

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

down.

! Do not install in:

— Places where it could injure the driver or

passengers if the vehicle stops suddenly.

— Places where it may interfere with the dri-

ver, such as on the floor in front of the dri-

ver's seat.

! Install tapping screws in such a way that the

screw tip does not touch any wire. This is im-

portant to prevent wires from being cut by vi-

bration of the car, which can result in fire.

! Make sure that wires do not get caught in the

sliding mechanism of the seats or touch the

legs of a person in the vehicle as short-circuit

may result.

! When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake lines, wiring) from damage.

CAUTION

! To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

— Allow adequate space above the amplifier

for proper ventilation.

— Do not cover the amplifier with a floor mat

or carpet.

! Place all cables away from hot places, such

as near the heater outlet.

! The optimal installation location differs de-

pending on the car model. Secure the ampli-

fier at a sufficiently rigid location.

! Check all connections and systems before

final installation.

! After installing the amplifier, confirm that the

spare tire, jack and tools can be easily re-

moved.

Attaching the Bass boost

remote control

Attach with tapping screws (3 mm × 10 mm

(1/8 in. × 3/8 in.)) at an easily accessible loca-

tion such as under the dashboard.

Tapping screws (3 mm × 10 mm

(1/8 in. × 3/8 in.))

Example of installation on

the floor mat or chassis

Place the amplifier in the desired instal-

lation location.

Insert the supplied tapping screws (4 mm ×

18 mm (5/32 in. × 3/4 in.)) into the screw holes

and push on the screws with a screwdriver so

they make an imprint where the installation

holes are to be located.

Drill 2.5 mm (3/32 in.) diameter holes at

the imprints either on the carpet or directly

on the chassis.

Section