- ページ 8
アンプ Pioneer GM5400T - Bridgeable AmplifierのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Pioneer GM5400T - Bridgeable Amplifier 29 ページ。 Bridgeable two-channel power amplifier
Pioneer GM5400T - Bridgeable Amplifier にも： オーナーズマニュアル (41 ページ), オーナーズマニュアル (48 ページ), オーナーズマニュアル (17 ページ), オーナーズマニュアル (17 ページ)
ページを印刷する
1
2.2 PANEL FACILITIES
A
What 's what
Front side
B
Rear side
To adjust the switch, use a flathead screwdri-
ver if needed.
C
1 Power indicator
The power indicator lights up to indicate
power ON.
2 BFC (beat frequency control) switch
Located front side the unit. If beats are audi-
ble while listening to MW/LW broadcasts via
car stereo, change theBFC switch using a
small flathead screwdriver.
D
3 BASS BOOST (bass boost level control)
switch
You can select a bass boost level from 0 dB,
6 dB and 12 dB.
4 GAIN (gain) control
If output remains low, even when the car
stereo volume is turned up, turn controls to
E
lower level. If distortion occurs when the car
stereo volume is turned up, turn these con-
trols to higher level.
• For use with an RCA equipped car stereo
(standard output of 500 mV), set to the
F
8
1
2
NORMAL position. For use with an RCA
equipped Pioneer car stereo, with max.
output of 4 V or more, adjust level to
match that of the car stereo output.
• If you hear too much noise when using
the speaker input terminals, turn the
gain control to higher level.
5 LPF (low-pass filter) switch
Switch the settings based on the connected
(EW5, ES)
speaker.
• When the Subwoofer is connected:
Select ON . This eliminates high range
frequency and outputs low range fre-
quency.
• When the full range speaker is con-
nected:
Select OFF. OFF outputs the entire fre-
quency range.
(EW5, ES)
GM-5400T/XJ/UC
2
3
3
4
4