- ページ 12

アンプ Pioneer PD-M407のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer PD-M407 40 ページ。 Multi compact disc player
Pioneer PD-M407 にも：取扱説明書 (40 ページ), 取扱説明書 (28 ページ), サービスマニュアル (32 ページ), サービスマニュアル (32 ページ)

ページを印刷する

TO PLAY ONLY DESIRED TRACKS/DISCS

Direct Program:

During normal playback or Magazine Hi-Lite Scan playback,

the track being played can be programmed.

1. Press the PROGRAM button to enter the program

mode.

2. To search for a desired track during normal play

back, it is possible to skip to succeeding tracks by

pressing the 4 1 or ¡ ¢ button.

Also, Magazine Hi-Lite Scan function can be used to move

from track to track through the disc.

3. If you wish to program the track currently playing,

press the PROGRAM button while the track is

playing.

÷ Direct programming is not possible during program

playback.

To check the program contents (PD-M427 only) :

During program mode, set the player to stop mode and press

the CHECK button on the remote control unit. The program

contents will be displayed in the programmed order.

÷ After confirming the last program step, the display will

show "0-00".

PROGRAMMING A PAUSE (PD-M427 only)

Inserting a pause in your program can be very useful when

carrying out recording. Press the 8 button on the remote

control unit instead of entering a track number. "PA" appears

on the display panel.

÷ For example, when recording on both sides of a cassette

tape, if you program a pause after the last track to be

recorded on the first side, program playback will pause at

that point to allow you to switch tape sides. To resume

program playback after the player enters pause mode,

press the 8 button on the remote control unit or 6

button on the front panel.

NOTES:

÷ A pause can be programmed only when the program

procedure is performed under stop mode.

÷ A pause cannot be programmed at the beginning of a

program (P–01), nor can two pauses be programmed one

after the other

÷ A pause inserted in a program is counted as one step.

÷ If a pause is programmed as the last step of a program, the

player will not enter the pause mode.

Downloaded From Disc-Player.com Pioneer Manuals

To erase a program (PD-M427 only) :

During program mode, press the CLEAR button on the

remote control unit.

The last program step is erased and the contents of the

previous program step are displayed.

NOTE:

Contents of a program can be erased during playback as well.

However tracks preceding the currently playing track cannot

be erased in this way.

To clear all of the program contents:

A. During stop mode, press the 7 button.

B. When the magazine is ejected, the program contents will

be cleared.

To modify the program contents (PD-M427 only) :

1. During program mode, set the player to stop

mode and press the CHECK button on the remote

control unit so that the program step to be

corrected appears on the display.

2. Enter the new disc number with the DISC

NUMBER (DISC 1-DISC 6) buttons and then press

the 4 1 or ¡ ¢ button so that the new

track number appears on the display.

3. Press the PROGRAM button.

÷ Repeat steps 1 through 3 to change other tracks as

desired.

÷ If the 4 1 or ¡ ¢ button is not pressed within

2 seconds when correcting the track number, the

displayed track number is automatically memorized.