- ページ 10

アンプ Pioneer SA-1520のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer SA-1520 20 ページ。 Fm/am digital synthesizer / stereo amplifier
Pioneer SA-1520 にも：サービスマニュアル (23 ページ)

ページを印刷する

NAMES AND USES OF PARTS

Tuner

@ PIONEER

ewam piaiTaL SYNTHESIZER TUNER TX-1320Z

FMIIODETUNIN| 3 MODE

STATION cath

[el

ellos

@) STATION CALL switches

These are used to recall preset broadcasting stations and to preset the

stations.

(2) MEMORY switch

This switch is used to memorize stations. When the switch is pressed,

the frequency indicator will flash. To memorize the frequency of any

station, press STATION CALL switch while the frequency display is

flashing.

3) BAND selector switch

This is used to select the band of the desired station.

FM: Press to receive FM broadcast.

AM: Press to receive AM broadcast.

(4) TUNING switches

These are used to locate the stations.

Push ''—'' switch to go to a lower, and '' +-"' switch to go to a higher

frequency.

() STEREO indicator

This lights when a stereo program has been picked up during an FM

broadcast.

(6) TUNED indicator

This lights to indicate when the finest tuning of a station has been

achieved.

@) FREQUENCY display

Permits reading the received frequency at a glance from the displayed

figure.

The FM band is indicated by MHz, and the AM band by kHz.

(8) FM MODE (AUTO/MONO) switch

Normally this is set to the off position (the fm MONO indicator goes off).

When noise spoils the reception of an FM Program, press the switch

to the on position (the fm MONDO indicator will now light). The program

of an FM stereo broadcast will be heard in mono. The setting of FM

MODE

switch

(on or off) is memorized

along with the station's

frequency in STATION CALL switches.

When using the preset tuning feature, reception will be in the mode

selected when the station was memorized. This switch will not function

for AM reception.

(When the auto tuning mode is selected, the AUTO indicator will now

light.)

AM/FM CHANNEL STEP SWITCH

The AM/FM channel step switch is located on the rear panel of the

digital synthesizer tuner. Before the Tuner leaves the factory, this

switch is set to the channel allocation system of the area in which

the tuner is sold. When TUNING switch is pressed, the frequency

display will change in the following way.

NOTE:

If the switch is set to the wrong position, correct tuning will

not be possible.

Consult your dealer if you are not sure about the channel allocation

system in your area.

;

hh:

Model destination

CHANNEL STEP

sh acl

CHANNEL STEP

switch position

FM mode

| AM mode

North America and

50/9

100/10

Continental South | 100 kHz/ 10 kHz | 100kHz

10kHz

kHz

America

Other countries

50 kHz/ 9 kHz

50kHz

9kHz

cen

SRN eee