- ページ 15

アンプ Pioneer SA-1520のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer SA-1520 20 ページ。 Fm/am digital synthesizer / stereo amplifier
Pioneer SA-1520 にも：サービスマニュアル (23 ページ)

ページを印刷する

TO USE THE COMPONENT CONNECTED TO THE

ADAPTOR TERMINALS:

Connecting the dynamic expander to the adaptor makes it possible to

enjoy the dynamic expander's effects.

'Adaptor component

(Dynamic expander)

2x | ®» Gal W

ante

nee es

MAN

——

OPERATIONS

[Connection]

(1) Set the POWER

switch to OFF.

(2) Remove the two connecting bars from the adaptor

terminals.

Connecting bars

NOTE:

Always remember to keep the connecting bars in place when these

terminals are not being used.

(3) Connect the adaptor component in accordance with

the

connection

diagram

in the

section

''Con-

nections."

[Operation]

(1) Playback the source.

(2) Operate the adaptor component.

The sound compensated with the connected adaptor component

can be recorded on a cassette deck. Signals modified with an

adaptor component can be recorded on a cassette deck.

NOTE:

Be sure to perform this operation with the adaptor components power

switch in the ON position. Even when not using the adaptor component,

its power switch must be left ON. If the adaptor component is switched

OFF no sound will be produced or the playback sound will be distorted.

For details, refer to the adaptor component's operating instructions.

Using

the Optional

VSP-333

Digital Surround

Processor

lf you connect a VSP-333, the main unit can be used as the front

amplifier of a surround system.

«ey

VSP switch

lo-o"

iin

RE)

0-0" |

[Connecting]

(1) Set the power switch to OFF.

(2) Connect the VSP-333 input/output cord to amplifier.

Insert

the

connector

until

it locks,

thus

ensuring

that

it is

connected.

When

disconnecting

the connector,

pull it in the

opposite direction while pressing the left and right claws.

(3) The VSP switch should be in the FOR USE WITH

VSP-333 position.

NOTE:

° Be sure the VSP switch is in the WITHOUT VSP-333 position when

a VSP-333 is not connected. In the ON position there will be no sound.

° Even if the VSP-333 is connected,

if the VSP switch is in the

WITHOUT VSP-333 position, VSP-333 volume level adjustment will

not be possible.

[OPERATIONS]

(1) Playback the source.

(2) Operate the VSP-333.

NOTE:

Be sure to perform this operation with the VSP-333's power switch

in the ON position. Even when not using the VSP-333, its power switch

must be left ON. If the VSP-333 is switched OFF, no sound will be

produced, or the playback sound will be distorted.

For details, refer to the VSP-333's operating instructions.

Recording with the VSP-333 (optional) connected

Sound recording from sources such as VCR

1, VCR 2, and

VDP

connected to the VSP-333

input jacks is possible

withthe

cassette

deck,

but

be sure

the SA-1520's

FUNCTION

switches

are in a

position other than TAPE.

If you select TAPE with the FUNCTION

switches,

recording is not possible from sources

connected

to the

VSP-333.