- ページ 40

CDプレーヤー Pioneer PDR-509のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Pioneer PDR-509 48 ページ。 Compact disc recorder
Pioneer PDR-509 にも：取扱説明書 (40 ページ), サービス回路図 (23 ページ), サービスマニュアル (23 ページ), サービスマニュアル (14 ページ)

ページを印刷する

PDR-555RW, PDR-V500, PDR-19RW, PDR-509

9.6.1 Verification of Disc Judgments

1. Tentative judgment by FZC (distinguishing

between CD/CD-R and CD-RW)

2. Tentative judgment by checking the RF existence

at TOCP

< If RF exists >

The disc may be a finalized CD or CD-R/RW or an erased CD-RW.

If the disc was judged to be a CD-RW in FZC tentative judgment, it

remains judged as a CD-RW (the disc status is CD-R).

If the disc was judged to be a CD/CD-R in FZC tentative judgment,

it is tentatively judged to be a CD.

< If RF does not exist >

The disc has strong likelihood of CD-R or CD-RW.

If the disc was judged as CD-RW in FZC tentative judgment, it is

judged as CD-RW. If the disc was judged to be a CD/CD-R in FZC

tentative judgment, it is judged to be a CD.

3. Tentative judgment (3) by checking the RF

existence in LIA (99:00:00)

When the setup is finished with the results of tentative judgments 1

and 2, the RF existence is verified while searching for LIA (99:00:00)

and executing AGC (gain adjustment).

< If RF exists >

The results of the tentative judgment indicates:

The CD may be a CD.

The CD-R may be a finalized CD-R.

The CD-RW may be finalized CD-RW or erased CD-RW.

< If RF does not exist >

The result of the tentative judgment indicates:

CD → no possibility

The CD-R may be a partial CD-R or blank CD-R.

The CD-RW may be a partial CD-RW or blank CD-RW.

4. Disc determination by reading the ATIP special

information

If the result of tentative judgment indicates the disc is a CD-RW,

and ATIP also indicates it is a CD-RW, the disc is determined to be

a CD-RW.

In the tentative judgment by checking the RF existence in LIA

(99:00:00):

→ Loads TOC, as there is a possibility that the

If RF exists

disc is a finalized CD-RW.

If no RF exists → Makes a decision depending on the result of

PMA loading, since the disc may be a partial

CD-RW or blank CD-RW.

If both the result the tentative judgment and ATIP do not indicate it

is a CD-RW, the disc is determined to be a CD-R.

In the tentative judgment by checking the RF existence in LIA

(99:00:00):

→ Loads TOC, as there is a possibility that the

If RF exists

disc is a finalized CD-R.

If no RF exists → Makes a decision depending on the result of

PMA loading, since the disc may be a partial

CD-RW or blank CD-R.

When the ATIP special information cannot be read, the disc is

determined to be a CD.

If the results of FZC tentative judgment and ATIP indicate it to be

of a different type, a retry is made by reversing the result of FZC

tentative judgment.

5. Disc-type determination by reading TOC

If MODE0 data are detected while reading TOC with CD-RW, the

disc status is changed to Partial CD-RW and the operation shifts to

PMA reading.

9.6.2 Auto-Adjustments

9.6.2.1 Calibration of Tracking Offset Adjust Ability

and Verification of the Temperature Sensor

These are carried out upon POWER ON and SETUP.

(1) Calibration of the tracking offset adjustment

ability

• When ADR_RFB and ADR_RFT are 1.5 to 3 V, the values are

stored in VRB_REF and VRT_REF respectively.

• When ADR_RFB are ADR_RFT are not 1.5 to 3 V, the mode-

control computer is notified through the TOKNG_F setting that

the initial values for the RF envelope signal cannot be obtained.

In this case, the mode-control computer generates a STOP

command if the setup step is before PCA. The values are stored

in VRB_REF and VRT_REF, respectively.

(2) Verification of the temperature sensor

Upon POWER ON, the temperature sensor is checked whether the

sensor shows a value within -15°C to 70°C. If it is out of the range,

the sensor is judged defective, and subsequent operations are made

in the temperature sensor defect status.

9.6.3 Tracking Error Level Adjustment and

Disc Determination

The tracking error level adjustment and disc determination are

simultaneously executed when a disc is inserted. The tentative

judgment made in this stage checks the RF existence in the lead-in

area. If RF exists, the disc is tentatively judged to be a CD. If no RF

exists, the disc is tentatively judged to be a CD-R.

However, if the result of the tentative judgment using FZC indicates

it is a CD-RW, the disc is determined as CD-R regardless of the RF

existence.